Can't select defrost

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 10, 2018
Threads
33
Messages
1,012
Location
Bozeman, MT
CfWjGna.jpg

I have a 1978 FJ40 and it was a cold morning in Montana. The "vent" and "heat" setting work just fine, but it seems to be binding up and I can't move the selector to the "def" position. My plan is to try putting a pair of vice grips on the lever at the bottom of the selector arm and seeing if I can free it up. I imagine someone has had this issue before and might already know a proper fix.

Thanks in advance!
 
Reach your fingers under the heater and give that flap a little help in moving up while you pull back on the lever. Maybe give the end of the shaft a little help when you pull back on the lever.


Check those old plastic bushings, one may be broken and binding up.


Don't use the vise-grips!
 
I don't think the smoke will go away until the snow falls. Too many big fires out west this year. I'm just happy I haven't been called up for fire duty, yet.
 
I don't think the smoke will go away until the snow falls. Too many big fires out west this year. I'm just happy I haven't been called up for fire duty, yet.

I'm just glad none of the big fires are local, hopefully the rain helped in Glacier.




I can't tell from the pic, does the top of the selector handle have an "L" shaped slot in it?
 
No, but the bottom does. The truck is sitting in the parking lot. Lemme run outside and grab a better picture.
 
9UGJnJG.jpg

Looks like I spoke incorrectly. The L-shaped slot circled in green is functioning correctly. The L-shaped slot circled in red is not functioning correctly, but it looks like I can manually move the flap by reaching under that foot well outlet. It moves easily, but now I'm thinking that the little guide in the lower L-shaped bracket is missing a part. It looks like the diameter is too small. It should probably look like the upper bushing?
 
9UGJnJG.jpg

Looks like I spoke incorrectly. The L-shaped slot circled in green is functioning correctly. The L-shaped slot circled in red is not functioning correctly, but it looks like I can manually move the flap by reaching under that foot well outlet. It moves easily, but now I'm thinking that the little guide in the lower L-shaped bracket is missing a part. It looks like the diameter is too small. It should probably look like the upper bushing?


That lower part of that arm definitely looks chewed up, along with the bushing. Maybe try to move the lower flap up while moving the arm back and forth to see if it will free up any.
 
It looks like the bushing is supposed to be a two part bushing with a retainer. So I'm missing the female portion of the bushing and the retainer clip. Do you know of a good source for these types of parts, or is this the sort of thing were I'll need to find something close and modify it to work?
 
That's kind of what I figured. I'll see what I can find. Thanks!
 
Back
Top Bottom