Can Diffs be swapped?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jul 25, 2008
Threads
11
Messages
46
Location
Kamloops, BC
I installed a factory complete front axle assembly with a factory electric locker in my RH drive 1991 JDM 80 series (HDT-1, automatic), I want to install an Aussie Locker in my rear diff but I have a factory posi. I talked to the engineers at Torq Masters and they said I need an open diff. My question is will the diff in my old front axle (which is an open diff) just bolt into my rear diff or are the ring and pinion opposite to the rear diffs? Switchable lockers like air or electric lockers will not work for my situation in my rear diff.
 
Never heard of a factory spool in anything,but who knows. The front gears are reverse cut so you cant just swapp them. I think you can take apart your old front diff and just use the carrier from the front and put the Aussie Locker in it and use it in the rear.

:cheers:
 
easiest thing to do is to go to the classified section here on Mud and find a used diff. buy it, get it built, then swap it into your truck.

if the factory LSD works, you can probably turn around and sell it for more than you paid for the open diff (or keep it for a trail spare). You get the added bonus of no down-time on the rig (ok, maybe an hour or two while you swap the diff). People with 40s or 60s might want the factory LSD for the front of their rig.

front and rear on an 80 are totally different beasts. totally not interchangeable.
 
Welcome to MUD Hoochie :flipoff2:
 
No, you cannot swap the two, they are very different. The front is a reverse cut high pinion, the rear is the opposite. The two also have different sized ring gears too.

You can swap the diffs on the 40,55,60, and early 70 series though.
 
Back
Top Bottom