Camber problem

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 18, 2005
Threads
310
Messages
3,647
Location
Houston, TX
Website
www.teqoutfitter.com
Ok guys I just rebuilt my front axle with new seals, trunion and wheel bearings. Brought the truck fro alignment today and I get some funny number Camber L/R ( -0.1/0.4). Before the axle rebuilt I have this reading (0.2/0.4). Seems like my right camber is in spec, but left camber got worse. What could be the problem, preload for the wheel bearing off? I wonder this could be the problem, I did drop one of the lower trunion bearing on the floor, but is not hard drop, just about 2 niches from the floor. :doh: Could that be the incident that throw my camber off? :rolleyes: Thanks guys
 
the camber isn't adjustable so something is out of spec. Wear on the spindle bushing? Wear on the spindle? Settling of the wheel bearings/trunion bearings? Wheel bearing pre-load? Bent axle?

Personally, I'd go re-torque everything, including the wheel bearing lock nuts, rotate the tires and have them check it again.
 
Actually I would consider negative camber better, however the discrepency is interesting. I would do as the midget says.
 
Are you running the factory rims? I ask this because I recently had to aggressively sand the inside of my rims. They just would no longer seat against the hub properly. There was a think layer of oxide I think. I bought a sanding drum for my cordless drill and just made a few passes around the inside so the rim would sit flush with the hub and I could still turn it while on there.

If your rims aren't sitting flat against the hub you might get eronious results.
 
Were ther any shims on the top or bottom of the trnion mounts??
AFAIK that is the only way to adjust the camber on these. Rick gives some sage advice and I would definitely retorque all of the trunion bolts and where the lower mount to the relay rod is just to be safe. With that small a variance I would not want to tear the axle apart and try to shim it back to spec. I would let it be.
Dave
 
The shims you are referring to are only for trunion bearing pre-load, NOT camber adjustment. Camber on these axles is not adjustable. If it's out of camber, something is not in spec.
 
Thanks guys, I would definatelly look into retorque everything and see how it goes. SOmething came into my head when I was driving, I was thinking to check with you guys. My driver side actually is about 3/4 inch lower than passenger side both front and rear after installing the ome lift. I put the label A spring on passenger side and label B on driver side. My bro LX is fine, but mine is not level. Could this affect the reading on camber? I know this would definatelly throw the caster off on my diver side. yes? no?
 
I'm also dealing with a camber issue. My right side is out of spec on the passenger side front. The truck's toe and caster is good and the truck pulls to the right. At this point, i suspect maybe the spindle is bent just a little, being the PO looks to have wheeled it a bit.

ANy idea what a new spindle would cost?
 
Back
Top Bottom