Cam Choices

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 26, 2006
Threads
5
Messages
9
hello, im lookin for a camshaft for my 327 conversion, i would prefer the biggest,most rough idling one yu can find, but i dont want to have to cut everything and double the springs and all that bull s@#t! rough idle but high torque is what i need. i need one that is ready to install. no fabricating. thanx
 
Rough idle is for high horsepower not high torque. Torque is made from compression and cubic inches. I would get a relatively small cam for a 327 in a Cruiser. Mine is a 446 lift and 212 duration @.050. I have the big chambered heads with flattops so I'm only at about 9:1 compression. If you have more compression, you can go with a little bigger cam, but you really cant go very big in a 327 and expect to have any low end torque. Big cam = big mistake in these vehicles!
 
sounds like the same camshaft i used , not much of of lumpy sound here but nice amount of bottom end , still has some balls tho , it's a cruiser not a muscle car . maybe this doesn't answer your question ,but anyways i am gonna post some charts on how i built my engine . for bottom end torque .still makes a decent amount of HP. i too wanted a lumpy cam , all my buds build muscle cars ,and they laugh at the sound of my engine whenever i hang with them ,they all run the biggest street drivable cams they could get in their muscle cars , they all had a ton of work done to thier heads tho , go with one of these and they just slide right in , no hassles i went for the 260

thsorens said:
Rough idle is for high horsepower not high torque. Torque is made from compression and cubic inches. I would get a relatively small cam for a 327 in a Cruiser. Mine is a 446 lift and 212 duration @.050. I have the big chambered heads with flattops so I'm only at about 9:1 compression. If you have more compression, you can go with a little bigger cam, but you really cant go very big in a 327 and expect to have any low end torque. Big cam = big mistake in these vehicles!
quest for torque 7.webp
quest for torque 9 (Medium).webp
quest for torque 10 (Medium).webp
 
cycler299 said:
hello, im lookin for a camshaft for my 327 conversion, i would prefer the biggest,most rough idling one yu can find, but i dont want to have to cut everything and double the springs and all that bull s@#t! rough idle but high torque is what i need. i need one that is ready to install. no fabricating. thanx


If you want a rough idle cam (to go with your over the frame rail headers) so you can sound cool that's fine. But cams with enough duration to cause a rough idle move the torque curve up the RPM range significantly.

In other words, your rough idle cam will make for a very lazy motor in the lower RPM range and will not begin to make real HP until wound out. The trouble with that is if you only put in the cam and not the other matched parts (heads, intake runners, valves) then you don't have crap.

If you really want a cam that will make torque and is a SMART choice with your other stock parts then keep the duration below 220* @ 0.050 lift.
 
Back
Top Bottom