Brake Question... HELP

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Nov 16, 2002
Threads
56
Messages
435
Location
Northeast PA
I am putting togeather the axel that i am swapping into my cruiser. When I took it apart the springs that go on the calipers were rotted off and I am curious how the anti-rattle one goes on there. Wondering if someone could post a pic for me. I hope to put the spring on and swap the axle in tomorrow so the quicker the better.

Thanks....
 
BandyRooster...

Im in greentown its exit 20 of i84... about 20 min from scranton. its a 78 fj40 axel in the front. with discs
 
does this help out dude?
084A.gif
 
Not really showing me what i need to see. #5 is the one I am confused about... Not too sure how it hooks in there once the calipers are in. Picture would really help.
 
i might be able to get a pic later. but basically the two dowels (#6) go thru the calapers and pads. then there are two holes on the dowels for which the spring locks them into place with a hole in the calaper the center of the spring snaps in. its got a wire grove type deal.
 
so, forget about that spring that goes up and down, focus on the one that holds the two pins in thats on the left side. there you can see where the center of the pin meets the caliper and holds the two dowels in.


caliper_clearance.jpg
 
Back
Top Bottom