brake problems

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Feb 23, 2004
Threads
51
Messages
117
1977 fj40

so i've been having brake problems. I can not get any fluid to bleed out of the rear brakes.


History

new toyota master cylinder (today)

switched out for a mini truck booster

I have rear disk conversion (chevy I think)

If I take off the line on the brake side of the proportioning valve and pump the brakes I get no fluid to come out.

front brakes blead fine.

I'm assuming this means I need a new valve. are they adjustable? rebuildable?
 
Did you bech bleed the new master? When I did my rear disc conversion I had to bench bleed the crap outta my new master, just a thought
 
sounds like your proportioning valve is stuck.sometimes if you leave the rear bleeders open and jack the front of the vehicle up it will allow the needle in the proportioning valve to move. leave it like this for a day and see what happens.

it could also be the master cylinder if it wasn't bench bled before you installed it. check the rear output at the master cylinder, if nothing comes out there fill a large syringe with brake fluid and squirt it into the rear outlet on the mc.
 
Back
Top Bottom