Brake pedal feedback

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Oct 16, 2008
Threads
13
Messages
109
Location
MO
I recently put new front rotors, pads and calipers on. I did a good job bleeding the brakes, I have a good, firm pedal. Sometimes when stopping, the brake pedal will "push back" and I hear noise from the brake pedal/MC area.

ANY IDEAS???? It happened before the brake job, and it happens now, its unsafe because when it "pushes back" the braking seems to cut out.
 
sounds ABS related FWIW, no expert just a hunch. good luck.
 
IIRC that is an indication that the booster is not air tight.

Check the FSM

2. Air Tightness Test

a. Start the engine and stop it after 1 or 2 minutes. Drepess the brake pedal slowly several times. If the pedal goes down furthest the 1st time but grandually rises after the 2nd and 3rd the system is air tight.
b. Depress the brake pedal while the engine isrunning and stop the engine with the pedal depressed. If there is no change in the pedal reverse travel after holding the pedal for 30 seconds, the booster is air tight.

At the side there the picture shows the pedal coming back up under the words "No Good" .

OR

Do a search on ABS, I believe if you remove the ABS fuse and the issue disappears you will have your answer.
 
Last edited:
Pulled the abs fuse and the abs light came on but the problem disappeared. I guess its time to clean some sensors and check electrical connections.
 
Back
Top Bottom