Brake Booster

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 10, 2006
Threads
99
Messages
501
Location
The Ghetto
What's the deal with replacing a bad booster with a mini truck one? I have a leak in my 72 FJ40 and in dire need of a replacement. Yes, there others out there for around $150-$320 but I could definitely not pay as much if possible. What are my options here? Mark....thanks for the heads up about your website. I found alot of useful stuff there. I will call your shop soon.
 
Boosters now... :) Make sure to adjust your brakes first (as per other thread). Yes, lots of boosters work. I put a 89 mini truck booster on mine. It bolted right up (for the most part). It was tight with clutch master, but still fit. Just remember the check valve. It is about a foot out from the booster on one of the vacuum lines. Look for a little white valve inline. I did have to cut down the push rod about 1/2 inch. You could also use a spacer instead of cutting down the push rod. It really isn't that hard. I got mine from a junk yard with the m/c still attached for $45. It works great, and it didn't cost near as much as a rebuilt one.

Good luck!
 
Hi All:

Yes, I used a V-6 Toyota "mini-truck" brake booster and master cylinder in my '74 FJ40 and it worked just fine, with just a few adjustments to the push rod and the brake pedal throw.

Good luck with your rig!

Alan
 
Back
Top Bottom