mattressking
10 digits to freedom
- Location
- United States
Ultimately had two radiator supports powder coated, only needed one.
Fits 2F Fj40 so I’ll just ballpark with 75-80. Outside of that is your discretion. Powdered gloss black.
Two issues:
1. Missing welded nut for the bottom most radiator/shroud bolt. 6/7 in great shape and thread chased. Sand blasting knocked it off and didn’t know until after powder. I’d just use a nut or riv nut (i can put a stainless riv nut in to match remaining hardware also).
2. A little bit of rust ate through near the bottom stud, no issue structurally wanted to note it. It’s covered up and not visible once installed.
$75 + shipping - local pickup preferred.
Fits 2F Fj40 so I’ll just ballpark with 75-80. Outside of that is your discretion. Powdered gloss black.
Two issues:
1. Missing welded nut for the bottom most radiator/shroud bolt. 6/7 in great shape and thread chased. Sand blasting knocked it off and didn’t know until after powder. I’d just use a nut or riv nut (i can put a stainless riv nut in to match remaining hardware also).
2. A little bit of rust ate through near the bottom stud, no issue structurally wanted to note it. It’s covered up and not visible once installed.
$75 + shipping - local pickup preferred.