bogurt intro

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jul 24, 2017
Threads
4
Messages
37
Location
Juneau
Hiya folks. I've been a lurker here for years and the search function hasn't failed me yet. I got an fzj80 for 900 bucks and will be taking advantage of the classifieds. I just figured it'd be rude not to say hello.
 
welcome :flipoff2::flipoff2::flipoff2: but if you dont have any pics it isnt real.
 
94 Fzj80. Bypassed egr, removed air injection stuff, universal o2 sensors. Stock otherwise. Was always interested in an 80 series and couldn't pass this one up for the price.

20170827_160749.webp


20170827_160806.webp


20170827_160918.webp
 
Parts on the way include: rear spartan locker, trailtech knuckle rebuild, manafre 30mm spacer lift. Tires, shocks, headgasket to follow. Also already installed trailtech trackbar and bumped the timing a bit. I might adjust the flapper for more fuel and do more timing as well.
 
Welcome. Looks like a hell of a rig for $900!
 
Fast craigslist reflexes..When I got it, there was a bad vibration above 30. Felt like it was going to rattle apart. Was loose wheel bearings with bad tie rod ends and 1 low tire. Tightened wheel bearings, installed new drag link, inflated tire. Problem solved.
 
On a side note, I better lookup the actual wheel bearing torque. I just tightened it till the wheel had no camber play when holding on the tire if that makes sense. They were loose when I got to em but not pitted. I didn't tighten em much..probly 10ft lbs or so. I always figure looser is better than tighter on wheel bearings.
 
On a side note, I better lookup the actual wheel bearing torque. I just tightened it till the wheel had no camber play when holding on the tire if that makes sense. They were loose when I got to em but not pitted. I didn't tighten em much..probly 10ft lbs or so. I always figure looser is better than tighter on wheel bearings.


Do't follow the FSM on this part. Follow @Tools R Us .....He goes to 25 LB-Ft and I concur. I use Lucas Red-N-Tacky 2 grease for the bearings. He uses "Green Grease" I think.

Welcome!
:flipoff2::flipoff2::flipoff2:
 
Thanks for that. I'll be searchin for the various methods and figure somethin out. So far, seen the fish scale method and the 10ft pounds after multiple rotations. I'll check out that method as well. I have a few days till my knuckle rebuild kit gets here. I use regular red'n'tacky for everything, I didn't know there was a 2.
 
Congrats! I think the early, white 3fe’s are the best looking of the 80 series. Hopefully no major rust issues, otherwise it seems like any 3fe 80 is usually good to go with some tune up work (and hoses, radiator, water pump, birf work.....). Even assuming all of that and then a little, seems ok given that entry price is almost like getting the truck for free!
 
Almost no rust. Birfields are silent. Electrical work on it is interesting but seems fine. It hit a tree and mashed up the driver side front a bit. I "fixed" it with a come-a-long to straighten it most of the way out and get the fender off the tire and used packing tape to remake a new headlight lens. The radiator was cracked near cap so I jb welded it. It has the look of something that was very well taken care of until it wasn't if that makes sense. I saw it parked next to road for a while so I walked up to make an offer.
 
Back
Top Bottom