Body surface question

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Nov 2, 2004
Threads
45
Messages
307
Location
Denver Colorado
Can't post pics since I am at work, however this is a pretty easy question I would imagine. I am down to the last stages of primer on my repaired 72' 40 tub and I have a question. I can see the spot welds in places no matter what I do to the surface. If I cover them I create a high spot, if I don't you see them through the primer, and of course in the end through the paint. I know that J**p's have these spot welds showing through right from the factory, do Cruisers have them as well? If so I will just keep it, other wise I am thinking I will have to grind them a bit.
 
dgangle said:
40's have very, very many and are considered by most to add character.


That's exactly what I was hoping, just looking at other peoples pics it's hard to see them, and since I seem to have the only 40 in my area I had no basis for comparison. Thanks! Guess I will start shooting it this weekend.
 
I forget when exactly but early(to mid 70's) 40's have very few spot welds that(are suppose to) show, if they are showing on the sides, then rust is poping the welds. latter 40's(like my 82's) have alot more spot welds that show(are suppose to), mostly on the sides, these are not rust pops but just the way it was made, the change showed up when the guage of the body was reduced.
 
Last edited:
I think the spot welds add a bit of "cruiser flavor" Mine would need a lot of grinding down to look smooth, especially on the wheel wells.

Mine is a 76 by the way.

Rezarf <><
 
Before I repainted my 71 FJ40, I noticed the spot welds along the horizontal side surfaces of both sides body tub, and both sides of the hard top. This is on a rust free tub, and the spot welds are definately dimples in the surface where the metal fused together. Toyota definately didn't bother to put body filler to make the surface perfectly flat. When I was having it repainted, my painter asked if I wanted them filled. I told him no, leave them "as is". I've also got several other unrestored early 70's FJ40s, and they are finished the same way. So, my advice (or opinion) is to leave them as is, if you want to replicate the factory look. FYI, the hard top metal is definately thinner guage sheet metal, and the dimples are more pronounced than the thicker body tub sheet metal. You can still see the dimples on the body tub, but it takes a more careful eye to see them. It's easier to see them by looking down along side the tub, rather than standing at a 90 degree angle to the surface.
 
Back
Top Bottom