Boards Are Off

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Yeah, I want mine off too, but I also have a bad case of wife rust. So what kind of solvent works on wife rust? I tried pb blaster and it didnt work.

Karl
 
Yeah, I want mine off too, but I also have a bad case of wife rust. So what kind of solvent works on wife rust? I tried pb blaster and it didnt work.

Karl

PB blaster won't work on wife rust. Try jewelry. It solves wife rust and works preety darn good as a leg spreader as well. :grinpimp:

Buck Buchanan
 
Yeah, I want mine off too, but I also have a bad case of wife rust. So what kind of solvent works on wife rust? I tried pb blaster and it didnt work.

Karl

Only cure I can come up with...
BMW_7_Series_2003_Modified.webp
 
Yeah, the only solvent that she mentioned might work is an Audi Allroad. For that kinda money, the running boards should fall off on thier own, and a new lift automatically installed.

Hmm, I could negotiate a weekly vacuum test on the owner and operator of said 80 series for a period of no less than one year too.
 
sad thing is as much as I hate them they have done a good job keeping all this AZ gravel away from the body.
 
i've thought about doing this for awhile....seeing those pics sold me

is it as easy as just getting under there and just start removing stuff?... i've got airtools so i figure that should help a bit with rust and the like

Yes, it's just that easy, get under, undo blots, no running boards. Except, living in CT, I'm sure you'll have some stubborn, rusty bolts. And as far as the air tools, I don't think they'll work on every bolt. The rear bolts/brackets are in a tight spot that will not allow for bulky tools. Notice the pic below: the two holes on the inside of the body, upper left of pic, are where the rear of the running board attaches. They can be a bitch!
9.jpg


But when you do get them off, look at the results!!!!
Before:
2.jpg

After:
6.jpg
 
Hey... does anyone have the small black trim pieces that fit under the back doors just over the running boards? I want some that I can cut up as part of a project, and I threw mine away after I removed my running boards.

You can see the piece in the top picture in the post above this one, just below the leading edge of the flair that moves with the back door.

Let me know if you have them and can part with them. I'd be willing to bet that CDan can't get these, but would love to be proven wrong. These are for the 94 FZJ80.

T.
 
Last edited:
Hmm, I could negotiate a weekly vacuum test on the owner and operator of said 80 series for a period of no less than one year too.

Well, you do own a BJ...
 
It is harder to buckle kids in a car seat with a lift after removing the boards, but Ive found it MUCH easier to set them in, and then do the buckeling from the opposite seats if you have 2 people.

Driver buckels the rear passenger side, front passenger buckels in the rear drivers side kid....
 
Back
Top Bottom