BJ42 Ignition switch with glow (1 Viewer)
- Thread starter arjen123
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
You could with some wring changes. The cylinder should be able to be replaced with a non-glow one. You would need to wire up a momentary (wilson) switch to glow manually.
I would ask though, there are a few sources for a new glow type cylinder and key set. Why not replace like with like?
I would ask though, there are a few sources for a new glow type cylinder and key set. Why not replace like with like?
On my truck the cylinder is from an fj40 and it still allows for turning the key backwards for glow.
I put a 42 ign switch inside it and good to go, return springs are in the switch not the cylinder.
Just doesn't say "glow" in the back position, otherwise you wouldn't know the difference.
Possible mine is worn out in some obscure way to allow this, but I don't think so.
I put a 42 ign switch inside it and good to go, return springs are in the switch not the cylinder.
Just doesn't say "glow" in the back position, otherwise you wouldn't know the difference.
Possible mine is worn out in some obscure way to allow this, but I don't think so.
and you should also have a stock glow toggle/rocker switch on the dash.
I rarely if ever use the cylinder key option
I rarely if ever use the cylinder key option
cityracerllc.com should have what you need,
might as well replace the worn outdoor locks at the same time,
then you’ll have the same key.
might as well replace the worn outdoor locks at the same time,
then you’ll have the same key.
