Birf Pic Need Advice

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 13, 2008
Threads
38
Messages
350
Location
Boulder, CO
I am into the axles today, this is the DS, I am switching it to PS to help wear.

History:
1996
175K
Not wheeled very hard, none until myself about a year ago. I stick to not that difficult trails and run 32's.
Axle history unknown.
Everything looks good in the axle.
I can feel grooves in the bell.
It doesn't pop or click w/o CDL locked, with CDL locked, it pops from this side while turning.

I don't really want to fork over more money for a new birf, and I want this done today, what do you all think?

Thanks!
IMG_0693.webp
IMG_0695.webp
IMG_0698.webp
 
My wear looked about the same but I had no clicking. I swapped sides.

Riley
 
Thanks everyone! It's in the PS now, I am finishing the job tomorrow.

Thanks
 
So, if it clicks you shouldn't be just swapping sides, but replace it (the clicking side or just do both)???

Sorry for the newby-ish kinda question! :D

In my experience clicking is one indicator of the amount of wear. If it wasn't clicking, it's taken apart and there is some wear, chances are it's relatively minor. If installed on the other side, so the main wear is on the other (relatively fresh) edges, the chance of getting more life out of it is good.

If it's clicking, it's more of a gamble, good chance it will start clicking again soon.

If it was popping/snapping it good for a paperweight.

Of course without seeing the joint, this is mostly an internet guess.:hillbilly: Pix can make big wear holes look flat or relatively little wear look like canyons. Hands on inspection is the best way to do it.
 
Back
Top Bottom