For Sale BIOR 100 series dual swing out (minor damage)

[Layonnn]

Location

United States

SOLD

$900

I was rear ended about 8 months ago by a Camry, see my build thread for pics of the collision. I had the bumper replaced with a Slee because they had one in stock at the time and Bump It Offroad did not.
It also includes the dual jerry can holder for the passenger side (it was not on the bumper when the collision happened, has been in the garage).
The damage to the bumper is minor and were I responsible I wouldn't have replaced it.
The main extent of the damage to my knowledge:
- there is a quarter sized spot of powder coat missing on the left side and a few scuffs on the bottom of the right side
- the sides appear to have been bent downwards about 0.5 an inch
- the tire carrier moves a little less smoothly, but that may be fixed by just adding some more grease to the bearings, doesn't seem much worse than before.

The bumper is located in Baton Rouge, LA. I'd highly prefer pickup or "mudship" as it weighs close to 250lbs and shipping will be rather expensive.

Please shoot me a PM or post a reply if you have any questions about the bumper.

 

[Layonnn]

One more photo.

 

[Cannon88]

I'd love to have this if we could figure out mudship. I'm in the Fort Worth area.

 

[LEX]

Its only a 6 hr drive. Road trip. I'm also eye balling it.

 

[Kross]

I'd be all over this if it wasn't so far. GLWS!

 

[dsmith13]

I'm having the same problem as everyone else, if it were closer to Denver, I probably would have already swung by with cash! GLWS!

 

[pmccraney]

Pm sent this a.m.

 

[Carhauler]

If that thing would fit an FJ60,

 

[Layonnn]

PMs replied to. I am going in order of the time stamp that PMs were sent to give first "dibs" on the bumper, as that is what i think is most fair.

The bumper includes the PS tire carrier, DS swing arm, and then the jerry can mount that is removable. The jerry can mount is this one (not my picture)

One more of the PS showing the amount it is bent down. There was about a 5mm gap between the plastic "mud flap" compared to the pic. I will also include these little flaps i made, they work wonders at keeping mud from going in to the sides of the bumper and give a little more finished look.

 

[Carhauler]

I can't believe it's still for sale. If I could modify it to fit my FJ 60 it would be sold. If anybody thinks I can modify it, please let me know. What a deal.

 

[Layonnn]

SOLD.