Below 4.10 gears...

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

jackbrad

15 Year 10 Year
Joined
Mar 1, 2006
Threads
134
Messages
671
Location
Charlotte, NC
Website
www.mattison-consulting.com
I need to find a set of gears (Front and Rear) that are higher than the stock 4.10 setup.

My goal is to be in the mid 3 range (3.50). There are a lot of reasons for this but, the simplest is that I am driving on the highway.

Has anyone ever found anything like this?

Jack
---------
1971 FJ40
 
anyone with a 60 going to lower gears are going to have these lying around for cheap or next to nothing, post up in the "wanted" you'd be suprised to find people are more then willing to help ya out here.

if you find someone parting out an fj60 just ask them for the thirds...they are probably interchangable to some extent
 
Welcome.


As has been pointed out, if you are going to be wanting to run a larger diameter tire, say a 33" or 35" tire, you will get about the same drop in ratio without having to open up the axles.


What are your plans for the truck? This will dictate the direction you end up taking...


-Steve
 
I am doing a complete refurbish of the truck. I doing a frame off but, will probably not go to the lengths some do. I will not sandblast the frame and every piece of it. My plan includes all new running gear (350 tbi, 4l60e trans, and some t-case) , upfit the brakes to disk, and add old man emu suspension. (Since I plan to do the steering upgrades as well. I really almost thinking I will change my mind on the frame.)

My expertise is in Chevy musle cars so restoring is a hobby I have had for a long time. I said refurbish in the first line because I plan to do with the truck as I see fit; and not really go back tediuosly stock. (I will do stock when stock was better than it is not and/or important to the character of the vechicle. )

My plan is to have a sunny day driver for 2 or three times a week. I don't really 4 wheel to much.. But, if I do I am not into tearing up this truck. (I woudl rather tear up something I don't really care about.)

My toughest challenge right now is getting a good set of gears and find the right transfer case. The trans is so long that it is really giving a fit problem and I don't knwo how I will resolve it.
 
Poser said:
I doubt you will need 3:70's with a 4L60 od tranny and a V8.
X2


Waste of time

the tranny will give you an overdrive of .7 or so compared to the 1:1 of stock..

evectivly in overdrive your overall gear ratio changes from 4.11(stock) to 2.87
 
If you still want a set, PM me I just swapped mine for a set of 4.88s and looking to get rid of them. I also have a set of 4.10s from Rascal's axles if anyone needs them.

--todd
 
Back
Top Bottom