Bad bounce in suspension--cause?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Aug 12, 2005
Threads
44
Messages
272
Location
Salt Lake City
The PO of my '78 FJ40 installed aftermarket springs (brand unknown) that he says gave it about 3" more lift. But the cruiser bounces like a wild stallion when I hit any kind of bump, even on pavement. It has adjustable Rancho 9000 shocks, and I have set them right in the middle.

Could the leafs just be too stiff? The fewer the leafs, the harder the suspension?

If the shackles are too tight and are binding on the springs, could that be the cause?

Thanks
 
how meany leaves are in this suspension?

Most "newer" suspensions run 5-6 leaves, thinner ones....maintains the ride much better.

If this set has 3 thick leaves, you are screwed...I ran a set of 3-leaf Rugged Trail springs for 2 days, took them off, gave them to a buddy a few years later, he cut off the bottom two leaves (now a mono-leaf) and still hauls those huge jelly-roll hay bales in back without squatting the springs... (he did say that it rides nices...finally...with those in the back)

:D
 
Are you saying that the ride is stiff, harsh? If so, yes, too tight shackles or spring keepers (the things that keep the leaves together) could cause it. Some brands of liftkits have very stiff springs, and IMO Rancho springs are among the worst. Rancho used to stencil their name on their springs but I don't know if they still do, and anyway it was easy for an owner to paint over.

There's no hard and fast rule like "The fewer the leafs, the harder the suspension" to go by.
 
woody said:
how meany leaves are in this suspension?

Most "newer" suspensions run 5-6 leaves, thinner ones....maintains the ride much better.

If this set has 3 thick leaves, you are screwed...I ran a set of 3-leaf Rugged Trail springs for 2 days, took them off, gave them to a buddy a few years later, he cut off the bottom two leaves (now a mono-leaf) and still hauls those huge jelly-roll hay bales in back without squatting the springs... (he did say that it rides nices...finally...with those in the back)

:D

Rancho also had an early 2.5" 3-leaf spring pack. I put a set of those on a cruiser years ago. I too took them off shortly afterwards because the cruiser was just painful to drive it was so stiff.

I'm running a set of those same springs now "mono-leafed" on a trailer and they work pretty good. Nice arch and flex but I don't ride in the trailer so I can't speak for the ride quality. :D
 
It has 3 thick leafs front and back...

So as a guideline, more, thinner leafs will give a softer ride? I plan to install new bushings and CCOT shackles soon to see if that helps. Will shocks have anything at all to do with this? Thanks
 
yellowstoner said:
So as a guideline, more, thinner leafs will give a softer ride? I plan to install new bushings and CCOT shackles soon to see if that helps. Will shocks have anything at all to do with this? Thanks


these things could all have a little to do with it, but in the end, you will not get a decent ride out of your truck until you ditch the three leaf pack springs....


probably not what you wanted to hear...but it is the truth.


Good luck!


-Steve
 
I think I am one of the only ones that ever got a decent ride out of a set of 3 leafers, but then again my 40 tips the scales at over 5k with all the spares I carry on board ;p

I don't recommend you carry that much spare weight around in order to get a smooth ride out of your springs, but you could put some weight on it just for a day to test the ride out under those conditions!

NOTE: I think I am also one of the only ones that ever managed to SNAP a Rancho 3 leaf spring! :eek:
 
If it bucking around you might look to the shocks. I ride with stock 3-leaf springs with a good ride. I have a set of RS9000 Rancho shocks underneath. One thing to remember, leaf springs all 'round don't necessarily offer a totally smooth ride.
 
65swb45 said:
I think I am one of the only ones that ever got a decent ride out of a set of 3 leafers, but then again my 40 tips the scales at over 5k with all the spares I carry on board ;p

I don't recommend you carry that much spare weight around in order to get a smooth ride out of your springs, but you could put some weight on it just for a day to test the ride out under those conditions!

NOTE: I think I am also one of the only ones that ever managed to SNAP a Rancho 3 leaf spring! :eek:
Ahh yes mark. But you have ALL the parts ever needed to fix a cruiser ;)
 
yellowstoner said:
I plan to install new bushings and CCOT shackles soon to see if that helps. Will shocks have anything at all to do with this? Thanks

all wasted money....I'll actually wager it rides worse if you put on extended shackles and new stiff poly bushings....

what shocks are on there now?

IMO, live with it, and get ready for an all new lift kit soon....
 
It's running the adjustable Ranchos

and I have them set right in the middle. Sounds like different springs are now on the shopping list. Or lots of sand bags for ballast.
 
Back
Top Bottom