Axle help needed please...

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Feb 6, 2008
Threads
10
Messages
24
Location
Seattle, WA
I did a birf replacement job about a week ago. I took out the stock birfields and put in chromoly. I put the inner axles in both sides as pack with the birfields. I followed the directions very closely left by Romer on assembling the axle.

Here is the problem: I went wheeling a few days ago and left the rig in the driveway. I went to air up the tires and noticed the cap on the end of the axle was off. It must have fallen off at some point while I was driving. I got to looking at the end of the birf and it was sticking out about an inch. I think it pushed the cap off. I pushed it back, but I think it has an excessive amount of play. Is it possible the axle shifted out? What would cause this? Is the inner axle supposed to click into the third member or is it just pushed into it as far as it can? Thanks, Boone
 
If you are running them in your 91 you may have gotten 'the wrong' birfields. The early ones are shorter and the later ones are longer. If you are running the later length ones, and I'm guessing you are, you need the later and deeper drive plates or the birfield stub axle will be effectively too long.
 
Your new birfs are longer than the old ones. You need to replace the drive flanges with the newer style, which are thicker to accomodate the longer birfs that came in later model year 80's.

EDIT: What CD said. :flipoff2:

-Spike
 
If you are running them in your 91 you may have gotten 'the wrong' birfields. The early ones are shorter and the later ones are longer. If you are running the later length ones, and I'm guessing you are, you need the later and deeper drive plates or the birfield stub axle will be effectively too long.

Your new birfs are longer than the old ones. You need to replace the drive flanges with the newer style, which are thicker to accomodate the longer birfs that came in later model year 80's.

EDIT: What CD said. :flipoff2:

-Spike

Son of a bitch! The lady at longfield told me they were all the same. I'm not positive, but I thought the stock ones that came out were the same length as the longfield chromoly's that went in.

Should they have about an inch of play? I can push the birf in until it fits under the cap just fine.

Also, where do I get the longer drive plates?
 
I think Longfield only makes 1 length, the later ones. There should be about 2mm of play and not more.

Call Cruiserdan for the longer drive plates. Roughly $40 each.
 
43421-60040, $40.53 each.


You missed by $.53.................:lol:
 
Back
Top Bottom