Auto-Locker/Diff Question

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

LFD2037

TEXAS LEXUS!
Joined
Oct 22, 2013
Threads
183
Messages
3,889
Location
Wax., TEXAS
I have an Aussie locker in the rear of my rig. It's been in there for about 2 years & has performed great.
I jacked up just the rear off the ground. W/rig in park, front wheels on the ground & rear wheels off the ground:
I was able to slowly, freely spin the PS rear tire at least a full revolution then the locker locked the tires, then I went to the DS & was able to slowly, freely spin that tire at least a full turn then the locker locked them.
Should i be able to freely spin a rear tire (w/it clicking from the locker)? Is this normal? I'm trying to chase down a thunk sound & happen to discover this in the process.
 
Any input?
 
Yes, one tire should spin. You may have to hold the other tire locked in the same direction to get the tire on the other side to spin (while making a clicking noise). Hold the opposite tire locked in the other direction and now the tire will spin in the other direction. Then you can switch sides and rotate the other tire in both directions. That is the normal operation.

Clunking and banging noises from autolockers are from it trying to switch drive sides when the other side is in the middle of its ratchet cycle.
 
I have the Lokka auto locker which I think used to be the Aussie Locker. Both wheels should be locked together and spin together when both are jacked up. The only time they spin independently is when you hold one wheel and spin the other, only then should you hear any noise from it (the clicking of the locker disengaging).

If one wheel spins freely without holding the other wheel, sounds like something is wrong.
 
Both wheels should be locked together and spin together when both are jacked up.

If one wheel spins freely without holding the other wheel, sounds like something is wrong.

This is not correct.

Without holding the other wheel firmly, then the wheel either may or may not ratchet. Holding it makes the behavior entirely predictable which is what you want when you are testing it for proper operation.
 
Back
Top Bottom