ARB locker: what is replaced?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 17, 2003
Threads
37
Messages
310
Location
Jacksonville, FL
What does the ARB locker actually replace?

I want to do a complete replacement of all the bearings in my axle and diff. I oredered the ARB's, but am still waiting for them. I didn't want to order all the bearings for the diff until I saw what the ARB came with/what it replaced. Will I still need a regular bearing replacement kit (all the bearings)?

I'm guessing I need a normal differential bearing kit, but was hoping to confirm what I needed. I don't want to have to wait for the ARB to arrive, so this way I can have the bearings ready to go when it comes.
 
Soul man, you got it right. The ARB replaces the differential carrier, so replacing all the bearings makes good sense. There are 4, plus the crush sleeve and seal. Your best option will be Toyota OEM, or one of the vendors here for a kit price. One of my buds got all of this stuff from Kurt at Cruiseroutfitters.
 
I think you are better off buying a r & p install kit. At the very least you should replace the carrier bearings and races. It can be difficult to remove the old bearings from the original carrier and set them on the ARB without damaging them. You'll will need to set the backlash. If the pattern indicates that you also need to reset the pinion depth, then you'll need a full set of shims and it is advisable to replace the pinion bearings and races also.

I've set up a few of these and in most cases the pinion shims had spun a bit and the preload had to be be redone. You can certainly try reusing your old bearings and shims, but if you find that the gear pattern is unacceptable you'll need to track down all the parts as you go. It can lead to a lot of down time and in the end you won't save much over ordering a full install kit.

If you're not comfortable with setting up your own gears, bring the ARB and the install kit to a driveline shop and have them set up the third member.
 
andrewfarmer said:
Be careful - I understand that ARB 'standardised' the carrier to suit all cruisers and the side bearings are now a different size (poss the same as an 80?) - might want to wait until it arrives...

Not a worry if you know which ARB part # they are sending you... I have all the install kits accordingly... :D
 
If your pinion bearings are OK and you aren't changing to fine spline pinion or different ratios you can get away with just the side bearings and save the crushsleeve/shimset work of the pinion.
All you'd have to do is set the backlash and that's done with the adjusting nuts. Andrewfarmer is right, I'm pretty sure, that ARB has "standardized" their bearing fit to the 80 series ones so it would be good to buy from someone like 'cruiseroutfit' above who knows all about that and will set you up right. Could be nightmare time otherwise.
 
Back
Top Bottom