ARB bumper does not fit

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Feb 21, 2007
Threads
3
Messages
54
Location
Persian Gulf
Heads up. I recently purchased an ARB winch ready bumper for my FZJ from a local 4WD shop. It was 1/4 inch wide on both sides of the frame. After a few phone calls, we discovered it was part of a bad batch from ARB and they swapped them after just a few days. It was not known how many were in the batch or how many got to the US. Sorry I do not have much more information. I have a purchase order number if you think it will help.
 
I was so close I thought maybe it had been wrecked in the past and tweaked the frame because the bumper that came off looked like a replacement. I did consider the BFH route until they said they'd replace it.

On another note. I read where the the Warn M8000 does not need an adaptor. Is this the same as the winch plate? Should it have come with the winch or the bumper? I did not get one and as a result, the motor hits where the bumper starts bending aft. I cut four 3/16ths squares out of aluminum with bolt holes to serve as spacers and this seems to solve the clearance issue. Anyone foresee any problem with this?
 
On another note. I read where the the Warn M8000 does not need an adaptor. Is this the same as the winch plate? Should it have come with the winch or the bumper? I did not get one and as a result, the motor hits where the bumper starts bending aft. I cut four 3/16ths squares out of aluminum with bolt holes to serve as spacers and this seems to solve the clearance issue. Anyone foresee any problem with this?

[hijack]

If the M8000 is anything like the XD9000 then yeah, you need spacers to move the winch motor back away from the ARB for clearance. Since Slee is basically in my backyard I just picked up some of the ones that they make. AFAIK neither ARB nor Warn includes these when you buy the bumper or winch.

The ones Slee have are long rectangular shaped spacers that extend from the top bolt hole to the bottom bolt hole. Two per side were required for the XD90000. I don't know if it matters that you used 4 square shaped spacers vs say 2 long rectangular ones?

Here is a link to some pics I've posted before...

https://forum.ih8mud.com/showthread.php?t=154612

[/hihack]
 
Thanks for the info, Corsair. The pics really helped. Looks like the four spacers should do the trick.
 
Back
Top Bottom