Antenna lead routing

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Malleus

contact@Restore4x4.com
Supporting Vendor
Joined
Jan 5, 2017
Threads
195
Messages
9,655
Location
Charlotte, NC
Merry Christmas to all!

Malleus the Younger and I were attempting to correct the many problems he inherited from the PO of his '95 80 series yesterday. The "professionally installed" aftermarket stereo included the bonus 4-foot gap between the antenna lead and the antenna pigtail. Since I didn't happen to have the connector on hand, (thank you Thing) and since mine is in the garage (still), I decided to swap my antenna for his.

Antenna lead connector.webp


I have it through the firewall, but I can't find the stereo lead end of the cable. It's behind the blower somewhere. It would be helpful if someone could post a photo of the PS firewall from inside, with the climate control stuff removed.

If anyone has a trick for "finding" the end of the lead from the engine bay, I'll be forever in your debt. I thought ahead and tied a string to mine when I pulled it through the firewall, so that's not going to be a problem for me, but it doesn't help us with his.
 
Last edited:
It's all the way up on the far right side (from inside in the footwell). pull the foot well panel off and stick your hand as far up into the top corner as possible. That is where I traced mine to before going a different route. If you grab it there, you should be able to track it down behind the blower.

If you are asking where the antenna plugs in on the inside of the truck, it's like 3" behind the radio and you need to remove the radio to access it.

I went through the nipple on the firewall with a long screwdriver and then a nut retrieval tool. It was MUCH easier this way and you can still seal around the rubber with RTV for a water tight seal.

 
Thanks. I have it in the PS footwell, I just can't reach it.

I was hoping to find a way to grab it without removing the blower.
 
Found it!

Interior firewall, behind dash panels.webp


I was lazy and chose not to open the A/C system, remove the cooling unit and the blower to route the lead behind the blower.
 
ewww - i have two antenna mounts on the way to get rid of the telescoping ones - - I am not looking for to these installs :\ For my '97, I better go ahead and do everything behind the dash - radio/usbs etc.
 
Jamie, get a 3 or 4 ft antenna extension to span the gap from the radio to the engine compartment. Then you can change antennas at your leisure without having to fish the firewall each time. I dont like the crappy antenna I put in, so I get to go thru the joy of firewall work again
 
FWIW, if you want to route the new antenna lead into the engine bay, through the antenna access in the firewall/PS inner fender, do what I did (on mine): tie a 6-foot length of twine to the radio plug end of the antenna lead. Then pull it through the grommet in the firewall. Now you only have to tie off the new lead and pull it back through.

Of course, you could do what Malleus the Younger and I have been doing for the last two days and remove the dash panels... but I wouldn't recommend it.

BTW, I'm working on a plug in harness connector for USB-charging connectors to install in the coin slots in the console. There's a live connector under the console I'm going to use. Won't help if you don't have the holes already (or if you have the cooler option, I think that's the connector I'm using), but you could always use one of the two blanks next to the rear heater switch. I'll post the result when I'm done with the design.
 
Back
Top Bottom