Another tire thread for 97 LC

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Feb 24, 2016
Threads
37
Messages
619
Location
Oviedo, FL
Hi!

I'm a new member (have been watching forums for a while though), and I have a quick question about tires.

On my 97 40th LC, I currently have the stock 275/70/r16 Michelin m/s tires. They're pretty worn out and I'm looking for a slight increase in size. No lift and no major off-roading in the near future.

I'm currently looking at the Michelin m/s2, 265/75/r16 and the 275/65/r18 tire sizes.
265/75/r16 - Michelin LTX M/S2
275/65/r18 - Michelin LTX M/S2

While searching the forum, the 265/75/r16 seems to be pretty popular but I don't see any mention of the 275/65/r18 so I'm not sure what to think about that. According to the tire size comparison, the r18's are slightly larger but have a smaller side wall.

Any opinions are welcome, thanks!
 
Just making sure, but you understand r18 = 18" wheel diameter...you'd need new rims.
265/75r16 are a good size

You could also get a 285/75r16
 
Just making sure, but you understand r18 = 18" wheel diameter...you'd need new rims.
265/75r16 are a good size

You could also get a 285/75r16

Nope I did not realize that, glad I posted this question then! I assume the r17's are also too large? Not sure what stock rim size is.
 
Your current 265/75 R16 should have been roughly 31" when new. 285/75 R18 is a popular size. It comes out to 32.8" although it varies based on manufacturer. I'm currently running BFG T/A KO in that size. Your speedo and odometer will read ~6% low versus you actual speed and distance.
 
Stock wheels are 16"

Stock tire size is 275/70r16, which I believe Michelin still makes an LTX/MS in that size. Most manufacturers abandoned the 275/70r16 because the landcruiser is pretty much the only vehicle that uses that size, and 265/75r16 is damn close in size and very common. You can get just about any tire you like in a 265/75r16.

Either 275/70r16 or 265/75r16 are close enough to stock to be considered "stock replacement." If you want to go bigger, there are also a few options: 285/75r16 and 255/85r16 are the most common. If you don't use the truck off road much, just stick with a stock size for best economy and cheaper tires.
 
Stock wheels are 16"

Stock tire size is 275/70r16, which I believe Michelin still makes an LTX/MS in that size. Most manufacturers abandoned the 275/70r16 because the landcruiser is pretty much the only vehicle that uses that size, and 265/75r16 is damn close in size and very common. You can get just about any tire you like in a 265/75r16.

Either 275/70r16 or 265/75r16 are close enough to stock to be considered "stock replacement." If you want to go bigger, there are also a few options: 285/75r16 and 255/85r16 are the most common. If you don't use the truck off road much, just stick with a stock size for best economy and cheaper tires.

Thanks for the info. I'm leaning towards the 265/75/r16 right now, I really like the 285/75/r16's but they don't seem very practical for a road cruiser.

Does anyone have any experience with the michelin ltx at2's in the 265/75/r16 size? I know I'm not doing any serious offroading but A/T tires looks so much better
 
If you go with the 285's and want the same look (tire/fender flair top gap) as stock, you will need to add 1" (30mm) spacers to the springs. (33's will be 1" taller than 31's)
Personally, I would go with 285's and 1" spacers if you have the ability to install the spacers. Here's my new to me "barn find" 97 with that setup on Duratrac's. Here's a iink for the spacers: 80 Series Coil Spring Spacers - Man-A-Fre
IMG_2459 97 land cruiser.webp
 
Thanks for the info. I'm leaning towards the 265/75/r16 right now, I really like the 285/75/r16's but they don't seem very practical for a road cruiser.

SNIP

Actually, there are places where the 80 was sold with 33" diameter tires. The truck's gearing responds well to tires like the 285/75 and 255/85 R16. Some even report increased mpg because of the favorable gearing. Given you're in Florida, you'd have to leave the state to notice any altitude-related power loss.
 
If you go with the 285's and want the same look (tire/fender flair top gap) as stock, you will need to add 1" (30mm) spacers to the springs. (33's will be 1" taller than 31's)
Personally, I would go with 285's and 1" spacers if you have the ability to install the spacers. Here's my new to me "barn find" 97 with that setup on Duratrac's. Here's a iink for the spacers: 80 Series Coil Spring Spacers - Man-A-FreView attachment 1217418

That looks pretty damn good!
 
Actually, there are places where the 80 was sold with 33" diameter tires. The truck's gearing responds well to tires like the 285/75 and 255/85 R16. Some even report increased mpg because of the favorable gearing. Given you're in Florida, you'd have to leave the state to notice any altitude-related power loss.

I've been considering the 285's and I'm starting to like those more now. My only problem is a friend offer me a set of 265/75/16's with barely any miles for 200 bucks. Hard to beat a deal like that, I have a lot of thinking to do...
 
Back
Top Bottom