ANOTHER QUESTION: heater

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Dec 9, 2004
Threads
101
Messages
1,454
Location
The West
i know i have back to back questions here but i am bidding on ebay and would greatly appreciate some advice.

I have a 6/70 fj40 and am bidding on a 76 heater. will this swap right in?

thanx, Rachel
 
do u think they would bolt up?
 
and is there a certain amount or style of wires that it should have to connect it to a 1970?

thanx, Rachel
 
Are you talking the heater core and assembly inside the truck or the blower part on the firewall inside the engine compartment? The assembly inside the truck looks like the mounting bolts, inlet, outlet and heater ducts are the same or very close. I could not measure the one instaled and it is pitch black out side now, plus the batteries are dead in my camera. Do you have your heater out now. I can try and find some batteries and take some photos with a tape of the mounting plate. The blower motor was already gone on the 76 when I parted it out.
 
Okie, Crockett is right, but just get a fresh air inlet from a later heater, too.
Otherwise should bolt up just fine. The defrost tubes on the older heaters are round where the connect to the heater and oval on the later ones.

Ed
 
isnt she asking about the rear heater?
the front had no wires.

the reason i ask is she's been looking for a rear heater, right?

BUT if it's the front heater, i'm running a 78 in my 69.
kinda interfers with the fresh air rod.
dont know if i had to change the defrost tubes or not (but i think i did)
 
wow this post is old. Yea i lost that bid but i found a couple of heaters at ron's shop. hes awsome! I swapped two different styles ( one a later model year and one an earlier model year) in the rear heater holes ( bolt holes) an d they fit! I would just like to keep it stock and cannot seem to find what an early model rear heater is supposed to look like.

Does anyone have pics..... yes i searched
 
okie said:
wow this post is old. Yea i lost that bid but i found a couple of heaters at ron's shop. hes awsome! I swapped two different styles ( one a later model year and one an earlier model year) in the rear heater holes ( bolt holes) an d they fit! I would just like to keep it stock and cannot seem to find what an early model rear heater is supposed to look like.

Does anyone have pics..... yes i searched

i've got one for my 69/40
i can take a pic tonight if you want...
 
2badfjs said:
i've got one for my 69/40
i can take a pic tonight if you want...


please if you could You have no idea how much i would appreciate it!

oh and if possible can you take a pic of what kind of connector shoudl be on there for a 69? thanks ALOT!
 
okie said:
wow this post is old. Yea i lost that bid but i found a couple of heaters at ron's shop. hes awsome! I swapped two different styles ( one a later model year and one an earlier model year) in the rear heater holes ( bolt holes) an d they fit! I would just like to keep it stock and cannot seem to find what an early model rear heater is supposed to look like.

Does anyone have pics..... yes i searched


http://tinyurl.com/jx739 This is my 71 rear heater.

The attached pic shows differences between old heater (on LEFT) and new heater (On RIGHT).
OldNew.webp
 
Last edited:
Back
Top Bottom