Another birf grease thread

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Mar 27, 2015
Threads
83
Messages
1,458
Location
Westminster, CO
So I've searched and read about grease.

I'll rebuilt my axle about 1500 miles ago or 1.5 years. I used the redline cv-2 grease and now I'm having a clicking from driver side borf at full turns. Sometimes it doesn't, sometimes it does.

During the rebuild I put some used birfs in that looked good with no damage.

I'm wondering if the grease not having enough moly is the reason. I know tear it apart and inspect birfs but the garage is full right now with a truck I'm parting out so I can't do that just yet.
 
I can't imagine anything short of running them bone dry would cause "good" birfs to click in only 1500 miles. Is it documented that the Redline grease you used is short on Molybdenum content?
 
I can't imagine anything short of running them bone dry would cause "good" birfs to click in only 1500 miles. Is it documented that the Redline grease you used is short on Molybdenum content?

Yes I read it only has .9 moly which I didn't know at the time.

I'm guessing the birfs I put in are just worn.
 
You could try flipping them side to side to get more use out of them.
 
I filled them 3/4 when rebuilding then drove for awhile and pulled the plug and pumped more in.

I'm not going to flip them. I'm just going to order rcv and change the grease
 
  • Like
Reactions: RFB
Yes I read it only has .9 moly which I didn't know at the time.

I'm guessing the birfs I put in are just worn.

I would think you could run Crisco in there for 1500 miles without doing much damage. If the axle seals failed it could of pumped a lot of the moly into the axle housing/diff. Would only take a few minutes to pop the square plugs and check grease level in knuckles to confirm.
 
Back
Top Bottom