Anchor Shackles

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 6, 2008
Threads
17
Messages
31
Location
Ohio
Hello again, I've been reading some of the archives regarding anchor shackles & I'd like to keep a few in the Cruiser. I have rookie questions: 1.) Home Depot (I was there this week) had some, but only went up to 3/8". I'd like them to fit over the tow hoops, so what size do I need without going too huge?
2.) Home Depot might not be the best place to get them, is there a place a can order from the web? 3.) Regarding the size, what are they actually measuring? In other words, with a 3/8" shackle, what exactly is 3/8"?
Again, many thanks for helping this rookie out.
 
on anchor shackles, I believe the "nominal" diameter (one advertised and stamped on it) is that of the loop (forgot, not entirely sure). Watch out if ordering unseen, though, cuz the pin is usually a bit bigger.
Same on D shackles, I think.
On Web shackles, though, the pin may be the same or smaller in diameter.

You want a shackle that is more than capable of handling the load (especially if a dynamic pull), will still fit in the hole/loop etc, be easy to connect to, but not too big cuz it gets heavier, unwieldy, and potentially a more dangerous projectile.


you want a place that have them all, try McMaster Carr... (not cheap)
 
How about photos or info of where they attach on a stock bumper rig?

Factory tow loops, under the bumper mounted to the frame rails. If the truck pulling you out has a hook on the end of his winch cable you don't need a shackle. If they puller uses a winch thimble (like I do) then you'll need a shackle.
 
Be careful when buying shackles as most you'll find on store shelves are cheaply made in 3rd world countries that are fast and loose with their load ratings. This is one part where I'd pay full retail from a reputable source that offers shackles intended for vehicle recovery. Slee, or other 4WD vendors. Being wrong on selecting this part could kill you or someone you love.

DougM
 
The measurement is the diameter of the pin. The the "wll" rating would be a working load limit molded into the "bell" of the shackle. The working load is actually lower than the absolute strength of the shackle in order to account for shock loading and such. Shackles are not designed to allow the load and the shackle pin to be parallel (no side loads)
2. load ratings: Crosby Anchor Shackles, Screw Pin
1/4" 1000 lb. safe working load
3/8" 2000 lb. safe working load
CM Theatrical Shackles
1/2" 2 ton working load limit
5/8" 3.25 ton working load limit
3/4" 5 ton working load limit
I believe these "wll" numbers refer to a load hoisted overhead with a safety factor of 6 to1. I am not sure how this would apply to our usage. Aside from reputable 4 wheel drive suppliers this hardware would be available from rigging suppliers (that typically deal with cranes, construction and theater rigging.
The "china" shackles are typically not rated.
 
Back
Top Bottom