Alternator Options

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Being the thrifty type, I would at least pull the alternator out and check the brushes and other internal bits. Clean it all up and see if it works. A number of guys spend time in hood-deep water and I don't believe it led to a rash of failed alternators. Take heart, take it out, and take it apart! :beer:
 
Go oem. And replace it with an identical unit as what's in your cruiser to avoid any over/under amperage. Good luck.
 
No one has one locally. (OEM) - I found 1 set of brushes here in Houston. I will be picking those up later today.

I am getting a pulled unit from a local scrap yard to get running today, and I will be rebuilding the old alternator to keep as a spare.

Eventually I will likely get the 150A bracket and go that route. I don't have time today to do that.
 
EDIT: I didn't have to remove the battery box or anything else. Just loosen the belts with a gear wrench, unbolt the alternator and wiggle it out/in.

the only think that I had to remove of better bolts acces was the PS pump reservoir and few cables conectctors .. just to have more space ..

Little patiend and you can get out the alt without much hesitation ...
 
the only think that I had to remove of better bolts acces was the PS pump reservoir and few cables conectctors .. just to have more space ..

Little patiend and you can get out the alt without much hesitation ...

True, I believe I did undo the PS reservoir bolts and unclipped the connectors on the factory ground wires. I also had the big oil filter on there which didn't help. :rolleyes:
 
Well, I picked up a used alternator from a donor at a scrap yard in Pasadena. 55 bucks out the door. Works great. I am going to rebuild the old one and keep it for a spare until I get the 150A alternator bracket.

Thanks guys.
 
Back
Top Bottom