alternator help needed

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 30, 2005
Threads
68
Messages
543
Location
Atascadero, CA
i went to pismo for my cruiser's maiden voyage. i found many problems most of which i fixed within a week. but i have one problem that i just cant figure out. i have a chevy 350 with the GM alternator. my problem is the the alternator isnt changing my battery. i put in a new battery and a new alternator trying to fix it but still nothing. i have checked all the wires and compared them to the owners manual and they all match up correctly. everything associated with it works like the amp meter but it wont charge the battery. does anyone have any suggestions or solutions to this problem?
any little clues or info would help.
thanks
 
It is pretty hard to imagine how the amp meter could be working and the battery is not charging, except if the battery won't hold a charge. The amp meter is directly between the alt and the battery and if the needle swings to the right, it indicates that current is flowing to the battery.

Which way is the amp meter indicating?
How do you know it isn't charging?
 
the amp meter only moves when i start the motor or turn on the headlights. other than that it doesnt move. i know it isnt charging because i let it run foir a while and the battery go drained. the battery does hold a charge if i dont run it.
 
I guess that means that it only deflects to the left? Does it move and then go back to 0 (the center)?

Measure the voltage across the battery and at the alternator B lug. If there is a difference in the voltage, there is a bad connection between the alternator (large white wire with blue stripe that is attached to the alternator B lug) and the amp meter.

If the alternator reads battery voltage (12V), try jumping directly from the battery + post to the field wire lug post (or the wire that is not the idiot light if you have an internal regulator alternator) on the alternator. If the voltage does not jump up a couple of volts, the alternator is bad.

If it does jump up, the regulator is bad (or the wire from the ignition switch to the int reg alt is bad).
 
thanks i will try that tomorow. hopfully it will be as simple as a wire or two.
 
Back
Top Bottom