Alignment question

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Dec 21, 2006
Threads
14
Messages
155
Location
spring, tx.
Just finished the front axle PM on my rig yesterday (thanks a million to 94 Newbie for all the TLC he showed my TLC!) My question is do I need to have my front end aligned now? We disconnected the arm from the bottom of the knuckle and did not disconnect it from the TRE. My truck is running straight with no pulling on brand new BFG 285/75/16's post-birf job. Just wandering if you guys that have done this p.m. had your truck aligned afterwards. BTW thanks for all the great write-ups they were very helpful( especially the part about being patient re-installing the DS axle....took us an hour to get it back in :doh:).

Jeff
 
I'll usually check the toe-in with a tape measure and set it somewhere around 3/16" in at the wheel rim. I'll only do this if a) I've never done it on that truck or b) I've changed or moved tie rod ends. If you're sure it was set right before you disconnected the end, it should be the same now.

-Spike
 
Thanks, it was in spec beforehand and did not mess with the TRE on the birf job so I'm gonna leave it as is for now.
 
Back
Top Bottom