can you post up your specs and dimesions you used?
looking for LWB / LV
looking for LWB / LV
Alcan Spring owners
- Thread starter bull
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
mine should be here this week I ordered them about 4 weeks ago I told them I wanted 4" of lift that the front would have a wincha nd winch bumper and the rear would have a 150lb bumperover stock as well. they seemed to think that would be pretty stock for weights. we will see I will post up some pics of them next to stock if that helps what else are you looking for???
Jason
Jason
- Thread starter
- #3
Thanks for the reply.. What were your eye to eye measurements?
ok m eye to eye were
ffront42"
and rear 50"
they seemed to to know what I wanted but I am not sure I accounted for the stock 2" or so arch. I will call them tommorow to make sure I am not getting a 4 total sprinng which would only be 2" over the stock arch and getting a 4" lift spring. we'll see
jason
ffront42"
and rear 50"
they seemed to to know what I wanted but I am not sure I accounted for the stock 2" or so arch. I will call them tommorow to make sure I am not getting a 4 total sprinng which would only be 2" over the stock arch and getting a 4" lift spring. we'll see
jason
They're fabbing mine this coming week if things go well. I also ordered a 4" lift.
My eye to eye (64 45 swb fixed roof) was 49" center to center. The SOR book shows this dimension to be 49.9" but also shows it a perfect horizontal measurement (dropping down from the rear eye).
Tom at Alcans also wanted some other info from me including the width of the hangar, the desired width of the springs and u-bolt info. I didn't have the measurements at the time and he said my spring widths are 2-3/4" but this weekend I measured and they are 3".
The width of the hangar was 3-1/4".
Hope that helps.
My eye to eye (64 45 swb fixed roof) was 49" center to center. The SOR book shows this dimension to be 49.9" but also shows it a perfect horizontal measurement (dropping down from the rear eye).
Tom at Alcans also wanted some other info from me including the width of the hangar, the desired width of the springs and u-bolt info. I didn't have the measurements at the time and he said my spring widths are 2-3/4" but this weekend I measured and they are 3".
The width of the hangar was 3-1/4".
Hope that helps.
I cheated. I just told Tom to make mine "just like Mike Galloni's";p
They've worked out very well.
So ask Mike.
They've worked out very well.
So ask Mike.