I searched and came up empty. Was looking for some baseline numbers for AHC in Techstream. I see all the ranges in the service manual. I'm specifically looking for someone to record the live data in Techstream for AHC. Would like the recorded data to go from low to normal to high and then back to normal. Would like to compare my numbers, specifically pressures and heights to others. Chasing an AHC issue right now which I may post about later this week for help. Anyone willing to do this sometime this week and upload it here or PM me? Please also state whether you have done the sensor lift and if you have any extra weight. I think it would be a good resource for anyone with AHC issues. Thanks.
AHC Techstream Live Data
- Thread starter razzyrazz
- Start date
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.
Radman I saw your post on other threads. Could you please explain how you adjust heights only through TechStream?
Thanks.
Here's how i did it:
AHC Height Offset Utility How-To
Height Offset can adjust a maximum of .8", so you move the physical sensors first, and then you have .8 to play with. 1mm of movement on the sensor equates to 2mm on the rig. In theory, assuming there’s enough stoke in the shocks, you might be able to add .8” on top of the “sensor lift” method...
forum.ih8mud.com
Thanks!Here's how i did it:
AHC Height Offset Utility How-To
Height Offset can adjust a maximum of .8", so you move the physical sensors first, and then you have .8 to play with. 1mm of movement on the sensor equates to 2mm on the rig. In theory, assuming there’s enough stoke in the shocks, you might be able to add .8” on top of the “sensor lift” method...