Advice for power steering issue

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Sep 9, 2007
Threads
39
Messages
118
Location
Kennedrunksnort Maine
Was leaking quite a bit of PS fluid, degreased undercarriage to try and find leak-the PS pump is only 6 months old, took it to mechanic for looksie....says leaking PS box. From what I'm finding on posts, some say no big deal and posts of $3000 job!! What is it? I was told looking at 6-12 hrs of labor to get it done-any idea of price for new PS box?
 
I have no idea in a new PS box .. ( just don't want to as anycase .. ) but unbolt the PS box it's a easy job .. 20 min as much ..

rebuit it could be a little tricky and maybe sent it to a rebuilder ..

I'm not sure if they work with 80 series PS box .. but are all the same ..
 
New gear box (they only come new--no remans) run north of $2000.

My recommendation is to get the factory rebuild kit from Toyota. Take off your gear box and send it to West Texas Off Road who specializes in PS gear box rebuilds. IIRC, they rebuild it for $150. You pay shipping.

Lots on MUD have used them to very good success and they do a very good job.

While you are at it, you should also probably upgrade to the later sector shaft and pitman arm from the 105 series cruiser. This is a good upgrade, albeit, expensive (~$450 or so for the sector shaft and pitman arm).
 
I just went through this last March.

My steering box had lots of play and had been leaking for a few years.
I purchased a used box with 120k from cruiserparts about $350 with fees and shipping.
I was sad when I first saw it. It was very dirty and had some surface rust, I don't see much rust in Texas.
I cleaned it up and installed it with no problems.
Took me about about 2 hours, with the beer and the cleaning.
The end result was fantastic, tight with no leaks...

The boxes are expensive. If you can handle the down time, I would second benos advice and have West Texas Off Road rebuild your box.

Good Luck, and do not pay for "6-12 hrs of labor" for the install...
 
I rebuilt my box on my 4-runner, I imagine the LC is the same. It was easy. I had to use an impact hamer to get the cover off, and getting the balls back in was fun, but not all that hard. It was interesting to see how it works, and for 30 bucks or so, wayyyyyy worth it.

I say rebuild it. Just don't paint it yellow.
 
First, degrease the engine bay and verify the box is the problem before you dig into the wrong part. There are a couple of choices. One, find a used box on MUD or at CARPART.com for ~$100-150 + shipping. Two, give it a quick overhaul yourself as Tenzig mentioned.

It is very likely that one of the seals has degraded and dried up to the point it won't seal well. Purchase a Gates Rubber steering gear major seal kit P/N 348437 (scroll to the bottom) which can be found for under $40 online. In about an afternoon or slightly more you can pull the box, reseal and reinstall your steering gear to nearly new specs. I do recommend you skip the replacement of the Teflon ring on the piston unless you can make up a heated oil bath and have a band style ring compressor the correct size. Unless you're suffering from a lack of steering power this shouldn't be necessary. As much as Dan and Onur's fleabags (term of endearment for my pets) need to eat, $2000+ should not be your first option, sorry guys ;).

A couple of threads showing the box disassembly and reassembly:
Dusty's porting directions - good pics
Porting thread on Marlin's forum - more good pics
 
Last edited:
Thanks for the advice

Called WT Offroad--full rebuild for $140 + shipping seems like a good idea based on my 182,000 mi, even if it's just bad seals. Curious about the suggestion to replace parts from 100 series when doing this job. Why?
 
The 105 steering gear has a larger diameter sector shaft. For the expense you can purchase a few used boxes and swap them out if you twist the sector shaft too much. If you're not wheeling in the stupid stuff it shouldn't be an issue.
 
Last edited:
I'm leaking PS fluid as well and I haven't diagnosed what is leaking. My steering seems pretty tight but I also have a substantial increase in pitch when the pump is under load. Can I rebuild the PS pump and will this take care of my noise?
 
I got a PS rebuild kit for my 92 at PSKITS.com. I think it was $9.95 after shiping. Stoped the leak, and the pump runs fine
 
I didn't read any of the replies so my appologies if someone has already said this.

I run full Synthetic so every chance it has to leak it doe UNTIL i introduced my friend LUCAS OIL POWER STEERING STABILIZER. Greatest product ever. try it out. just follow the directions.
 
Looks like the steering box

So it looks like the steering box but it is inconsistent in the rate of leaking. My gut tells me that the kit that West Texas Off Road does for the $140 rebuild is worth-while. Anyone got another view/opinion? She does have 180xxx miles so....
 
Back
Top Bottom