Actuator, keeping it dry

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Broski

I love Wheelin my 80
SILVER Star
Joined
Dec 3, 2015
Threads
89
Messages
10,952
Location
At the edge of the Pacific ocean
I'm rebuilding my actuator, like most I found it to be contaminated by water. I have the the new o rings & seal. My question is this there any other steps to take to keep water out, has anyone extended the breather ?
 
67B27973-AE6B-4082-8D2D-4CDD0B07D31B.webp
10D98722-A786-47C5-B187-3CF39B2F99E6.webp
 
I was amazed I was able to get it to work in this condition
 
I would seal it up with some rtv
 
Yep, seal it up and extend the breather. The rear one is in a poor location, pokes out of the harness, between the frame and body, over the LR bump stop. Clip the end of it off, get some hose to fit and run it into the jack compartment. Axle and actuator breathers terminated near the fuel filler.
Joe_70.webp
 
Yep, seal it up and extend the breather. The rear one is in a poor location, pokes out of the harness, between the frame and body, over the LR bump stop. Clip the end of it off, get some hose to fit and run it into the jack compartment. Axle and actuator breathers terminated near the fuel filler.
View attachment 2071331
Thanks Tools for your kind informative posts , Your are a great asset to this forum
 
Back
Top Bottom