AC Dryer

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jun 1, 2006
Threads
104
Messages
573
Location
North Jersey
This past weekend I retrofitted my old R12 system to R134a. I flushed all the lines, condenser and evaporator. Replaced all the o-rings, expansion valve, and dryer. In addition I flushed the compressor with new Ester oil and then added the proper amount. All this was done this past Sunday and I won't have it evacuated until Wednesday three days later have I ruined my dryer and contaminated my new oil with moisture by not having it evacuated immediately or will the vacuum pump recover any moisture in the system?

Thanks
George
 
This past weekend I retrofitted my old R12 system to R134a. I flushed all the lines, condenser and evaporator. Replaced all the o-rings, expansion valve, and dryer. In addition I flushed the compressor with new Ester oil and then added the proper amount. All this was done this past Sunday and I won't have it evacuated until Wednesday three days later have I ruined my dryer and contaminated my new oil with moisture by not having it evacuated immediately or will the vacuum pump recover any moisture in the system?

Thanks
George


You'll be fine George.

Just have the shop pull a deep vacuum on it for at least 45 min- 1 hr.

Congratulations on doing your conversion the "correct" way!
 
My thanks to you guys for putting my mind at ease. You would think that dryers should only be handled in nothing less than a "clean room" the way everyone talks about them you would think it will be ruined by ambient air in a matter of minutes! My local shop said he will evac it for an hour, he said he does it that way all of the time.
 
Not replacing your dryer while having it apart is asking for trouble down the road. The dryer keeps the moisture out of the system to prevent icing at the expansion valve. If it is the original dryer, it needs to be replaced, especially since you had the system open.

Your AC will work fine, but it will ice up down the road.
 
Just make sure you pull it into a vacuum down below .5 atmospheres for a while before charging the system. That will remove the moisture and let you know how good you did on the component replacement (if you have any leaks). You should be fine if you do this...
 
A SUCCESS! Cold A/C just in time for winter, well at least its done. My local shop ran a vacuum on it for over an hour and he said everything looks good. The last thing I have to take care of is the bearing in the compressor clutch its making noise but shuts up under load with the compressor engaged. One thing at a time.

Thanks to all:beer:

George
 
Back
Top Bottom