ABS Just Befor Stopping

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Mar 13, 2003
Threads
834
Messages
5,790
Location
North Front Range, CO
My ABS feels like it is activating when braking in city driving. It kicks in just before the vehicle stops.
It doesn't do it on every stop but over the past couple months it is happening more frequently. Over the past week its happening more and more.
I had the birs out last week and all looked well.
The ABS light doesn't come on.
I did a search with no luck.
 
Assuming your fluid is full, how does it check out? Has it ever been flushed? If so, how old is the fluid & you can have it checked for copper content and moisture content (water). With that many miles it could be the modulator, but I wouldn't call it dead until you check all basics. I would think the ABS lamp would be on all the time if there was a bad sensor or wire.
 
It's due to be flushed. The current brake fluid available in my area sucks. I just tested all the brake fluid that my local auto parts stores carry & found only 2 of 8 that were moisture free. The winners were Motul RBF600 & Autozone brand Heavy Duty Dot 3. Both were in plastic bottles. I was always told plastic was bad. Anyhow, it wouldn't hurt to flush your system top to bottom. You may just have small particles in the system caused by years of use.
 
Some repair shops have test strips that will tell you if there is copper contamination. I have a small electrical tool for moisture testing. You may have to call around to see who has these in your area.
 
I have had the same problem for over a year. it started out occasionally, now it seems like every stop the abs activates. I flushed the brake fluid, twice, and cleaned all the sensors. I am at a loss. however, I did notice the problem got worse when I replaced my front brake pads with 100 series pads. sorry I am no help, but just wanted you to know you're not alone!
 
I have my ABS fuse out for that problem. I suspect FJBen is correct. I think one sensor is sensing magnetic a gob of metal shavings on it, and thinks that wheel is stopped (skidding). That wheel is perhaps ignored until the other wheels are close to it's speed, then the ABS activates to try to get that wheel rolling. I'll get those sensors cleaned one of these days, hopefully before winter.
 
I had the same problem. It went away after front axle service. Apparently the reluctor ring had become magnetized and collected small bits of metal in the grooves and was read that the wheel had locked as I stopped. I cleaned the sensor and ring and have not seen the problem since.
 
Clean your ABS sensors. Most likely it's one of the rear sensors. It will have magnetic shavings and stuff all over it. This causes the ABS to come on at stops.

Free and easy :D

What he said. More than likely you have metal shavings on one of the sensors that is causing the premature activation.
 
I also think that it is a dirty sensor, but the fact that you had the birfs out recently is a concern. Many people forget to remove the sensor while taking the front apart and hit it. I am not saying you would do that but it is easy to remove check and clean all 4.
 
Back
Top Bottom