ABS and Diff lock light won't go off

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 7, 2005
Threads
314
Messages
1,336
Location
Dallas, Texas
While I was messing with my center console..I put the tranny in "L". The ignition was off. As I started the truck up.....I and put it back in "H"...for highway driving Now, the ABS light AND "center diff lock" light has stayed on. Any suggestions please?
airlaird
 
While I was messing with my center console..I put the tranny in "L". The ignition was off. As I started the truck up.....I and put it back in "H"...for highway driving Now, the ABS light AND "center diff lock" light has stayed on. Any suggestions please?
airlaird

Is the differential actually locked? Try and move it back and forth to see if that disengages the center locker.
 
I've tried moving it back and forth...no change. I don't have front and rear lockers
airlarid

How far, Ashleys sometimes takes 100 yards or so.

Take it down the street at slow speeds.
 
Well I can't tell if the center diff is locked...other than the dash light saying it's on. Is there a fuse I need to check?
airlaird
 
set the truck so that the CDL should be locked, place the t-case and tranny in neutral and then lift one front tire off the ground. If the wheel can be rotated the CDL is open if not it's locked. If it's locked then the indicator switch is probably not working.

I'm going through my lockers right now and with the engine off you can hear the individual actuator motors turning when switched. Right now my front actuator is turning but the indicator is still blinking. This is today's job.
 
Help Please!

OK, my center diff lock IS LOCKED....it chirps when I turn. I can't get it out of low...please help. Should I pull the diff lock 60 amp fuse??? I do not have a CDL switch...but I can use the flasher light switch.
HELP!
airlaird
 
OK, my center diff lock IS LOCKED....it chirps when I turn. I can't get it out of low...please help. Should I pull the diff lock 60 amp fuse??? I do not have a CDL switch...but I can use the flasher light switch.
HELP!
airlaird

1. Breathe.
2. Drive your vehicle to a place with low traction, like a gravel lot or a field.
3. You probably are experiencing drive train windup, which means that you have a lot of stored energy in your drive train, causing added pressure at the center differential, which won't allow it to disengage.
4. While on the field drive in slow circles in forward and reverse. You are trying to get the front and rear axles to move at different rates. That will allow the diff to disengage.
5. Pulling the fuse will do nothing. You are already locked. Pulling the fuse will leave it locked.
6. Work the transfer case lever from high to low some if you need to.
7. Post results.
 
No luck on that either. I spent about 15 minutes in a field. Can this be driven at ighway speeds...my wheels are chirpin when I make turns?
airlaird
 
No luck on that either. I spent about 15 minutes in a field. Can this be driven at ighway speeds...my wheels are chirpin when I make turns?
airlaird

Yes, it can be driven at highway speeds. The tires will chirp when you turn because the front axle and rear axle will be rotating at the same speed. This has been discussed before, but the consensus is that driving with the diff locked is not a problem.

I don't mean to be too simplistic, but did you try reverse? Did you drive in reverse when you were in the field?

Good luck.
 
No luck on that either. I spent about 15 minutes in a field. Can this be driven at ighway speeds...my wheels are chirpin when I make turns?
airlaird

It can be driven highway speeds, but be aware that it will handle slightly differently and will slightly increase tire wear.

Turn the key on with the motor off, shift it back and forth, what do you hear, is the relay clicking, the actuator motor running?
 
Back
Top Bottom