A/C Compressor Service/Shipping Plate Availability?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Mar 17, 2008
Threads
42
Messages
206
Location
Dayton, OH
Hey guys, I'm almost finished replacing the original bum A/C compressor with a new Denso unit. As you all know the new one does not come with the service/shipping valve plate on the top. It looks like someone has screwed around with it previously as a couple of the 8mm bolts in the plate are rounded and I am unable to get them off. I called the local dealer and he didn't really know what I was talking about and just tried to sell me the whole compressor for $600+. Anybody have the part number of that plate/know if it is still available? Similar to below...

auto-conditoiner-compressor-Denso-10PA20C-for-Toyota.webp
 
Tagged because I'm about to do mine.... Does that not swap over from the old one?

I assumed so since all the aftermarket units do not come with one on top but the bolts were really hard to crack (two were already partially rounded and wouldn't budge), and that was after being soaked for a long time with some PB Blaster.
 
A new compressor should come with a blank plate, need to swap the manifold off of the old one. Should be held on with allen bolts, IIRC, 6mm.
 
Tough when the small ones strip.... Vice grips? Bolt out? Tap a smaller socket on? When In doubt, you can always grimd the heads off
I wasn't sure about grinding the heads off since the head is recessed in the plate and I couldn't get vice grips to get a good enough bite with the space available :/

Is think I have a used one I would sell , but I am out of town right now . PM me next week and I will go take a look in the barn .

I appreciate it but I ended up getting it off, I found a machine shop that was able to drill them out and save the plate! Was more than I planned cost wise though. :crybaby:
 
Back
Top Bottom