97 LX450 Part Out

Joined
May 21, 2012
Messages
572
Location
Lenexa, KS
Thought I would start a separate thread versus posting in the Garage Sale thread so I don't junk that one up.

I am going to try and keep this local to start with.

I am parting out the black 97 LX450 that I have. It has approximately 390,XXX miles on it. From what I can tell by posts from the original owner, the motor has about 200,XXX miles on it but it is toast.

Lot's of stuff left on it. If you don't see something you are needing in the pics, still ask because I may have it.

If you interested in something, post up what you are interested in and I will get you a price.

Plan is to start pulling the front clip off over the next week and then yank the motor, transmission, and transfer case.

Hood has already been promised to @raynyc pending his inspection.

Asking $250 for the set of front seats. Not sure on the condition of the gears for front to back movement. Drivers seat has a small tear starting (see pic) and could use some leather conditioner. Passengers seat is near perfect.

1937351



IMG_8986.jpg


IMG_8987.jpg


IMG_8971.jpg


IMG_8981.jpg
 
Joined
Jul 9, 2012
Messages
1,900
Location
South KC
I'd be interested in:
- The driver side window switch assembly
- Air bag computer
- 2 of the interior door light covers
- rear side markers if the same for the toyota version???
- rear left slider window trim/vent on the rear section.

I'm sure I'll think of more.
 
Joined
Nov 9, 2012
Messages
7,721
Location
Olathe, KS, USA
Right rear interior door panel.
Rear lower tailgate.
Spark plugs and look covers on top of engine (front and rear).
Fan shroud if in good shape.
Chunk of the cab after it's all done to work on cabin air intake. I need a section of the firewall, cowl, behind RF fender, maybe up into the A pillar.
Oh s*** handle plugs.
4 oh s*** handles
How's the dash pad?
Speedometer.
Sunroof assembly (especially if it works)
Interior headliner if in good shape
Sunroof air dam if not broken

Probably more but not enough money.
 

subzali

 
Joined
Jan 31, 2005
Messages
3,568
Location
Denver CO
Would you be willing to ship items? Looking for two unbroken interior door handle bezels and a couple nuts/caps to hold down the 2nd row steps.
 
Joined
May 21, 2012
Messages
572
Location
Lenexa, KS
@cjmoon

- The driver side window switch assembly

Have it. Not sure on functionality but easy enough to check.

- Air bag computer

Should be there. You’ll have to tell me where to find that. I assume under the dash with yellow wires plugged into it.

- 2 of the interior door light covers

Easy enough.

- rear side markers if the same for the toyota version???

I’m pretty sure they are the same.

- rear left slider window trim/vent on the rear section.

Don’t have that one anymore.

I’ll PM you some prices.
 
Joined
May 21, 2012
Messages
572
Location
Lenexa, KS
Right rear interior door panel.

Has a couple marks but may clean up fine.

Rear lower tailgate.

In good shape. Holding it for you.

Spark plugs and look covers on top of engine (front and rear).

Got it down. They do have the Lexus emblem on them. Not sure if you can roll that fancy.

Fan shroud if in good shape.

I’ll check the shroud. I honestly don’t remember condition.

Chunk of the cab after it's all done to work on cabin air intake. I need a section of the firewall, cowl, behind RF fender, maybe up into the A pillar.

It’s yours when i get that far into it.

Oh s*** handle plugs.

Got you down for them.

4 oh s*** handles

Got you down for them.

How's the dash pad?

Dash pad is in good shape. No cracks. I’ll give you a price for it.

Speedometer.

I assume the whole cluster. I’ll put you down for it.

Sunroof assembly (especially if it works)

Not sure on functionality but we should be able to check it.

Interior headliner if in good shape

It’s not in bad shape. Little dirty but may clean up just fine.

Sunroof air dam if not broken

It’s not factory. Glued on aftermarket one.

I’ll come up with prices and PM you.
 
Joined
May 21, 2012
Messages
572
Location
Lenexa, KS
I am in need of two passenger side doors
Front passenger door looks good. Rear passenger door has a small door ding/dent in it. You good with LX450 doors with the cladding on them? The holes can be filled relatively easy if you use the same process I did on mine.

I’ll PM you.
 
Joined
May 21, 2012
Messages
572
Location
Lenexa, KS
Would you be willing to ship items? Looking for two unbroken interior door handle bezels and a couple nuts/caps to hold down the 2nd row steps.
Unfortunately those are cracked and missing the nuts for the 2nd row steps. Might check with Wits End for those?
 
Top Bottom