95 o2 sensor

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Dec 24, 2017
Threads
14
Messages
82
Location
Va
I have searched and found that it seems the best course of action when these sensors fail is to buy the the original Toyota kit that includes both sensors and replace both.

But, most of the info on here pertains to 94 or older which is obd1. Does the same hold true for obd2?
Should I replace both when I only have a code for one?
I can’t seem to find a 2 sensor Toyota kit for a 95. Is it available?
With a 95 do aftermarket sensors work just as well?

Thanks
 
Plugged right into my harness, came with the gasket/seal for each.

Did not come with new studs/nuts which I needed after having a lot of work to remove my old sensors. Unless yours o2 nuts are clean start soaking them with penetrating oil now, buy the heat/extraction tools ahead of time, and have an m8 x 1.25 tap on hand to prep for installing the new studs should you need to replace yours. Don't forget the anti-seize either.
 
Yes, if one is gone the other is on it's way. They are both old.
I'd buy two of the rear sensors. The harness is longer, and they're cheaper. Yes, they plug into the harness.
 
I'd check the O2 sensor itself to make sure it's actually bad. I had a broken wire on one of the heaters for mine.
 
Early model 95 can be obd1, so figure that out first, do you have diagnostic port inside the truck, if obd2 then you could get from amaxon get denso, if obd1 get kit from Toyota they will be ntk
 
Early model 95 can be obd1, so figure that out first, do you have diagnostic port inside the truck, if obd2 then you could get from amaxon get denso, if obd1 get kit from Toyota they will be ntk


Has a data port at drivers knee. And airbags. Code reader my next purchase!!
 
I'd check the O2 sensor itself to make sure it's actually bad. I had a broken wire on one of the heaters for mine.
Plan to pull it in shed on Saturday. I'll check them real close along with a good soaking of pb blaster
 
Ok so I got a code reader today and confirmed the code I have is 0135. I’m going to check wiring harness tomorrow for burns or broken wires. If that looks good going to order o2 sensor.

So what I’m gathering is the denso sensor works fine for the obd2 LC?
 
Easiest way to check for a broken wire is start pulling plugs and checking to see if you have continuity between the sensor and the plug you pulled. I never actually found where the wire was broken on mine. I pulled the plug right from the computer if I remember right. I also used a power probe which maybe it easy. Could do it with a volt meter with one of those continuity clamps to obviously.
 
Back
Top Bottom