92 cruiser overheating underload

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jun 22, 2014
Threads
6
Messages
19
Location
sisters oregon
Hey guys wondering if somebody can help me out.
I have a 92 cruiser with 190k that runs great but now weather is in the 80s I have noticed the temp gauge will head up to almost red under pulling 2k trailer or climbing hills. But flat driving I'm fine.
I think head is OK. Can't find any leaks. Lower hose is kind of flat. I can squeeze shut with hand. Otherwise seem in good condition. The whole radiator gets hot. Doesn't lose and liquid but today it did run over on overflow tank. Water pump doesn't sqeal. If I replace do I need OEM. Because where I live its a pain to order and takes days. I'm thinking cap then thermostat( is it on top) and maybe A flush
Any help where to start would be great
 
You do not need OEM parts, its just preferable due to the quality of the OEM suppliers. I would do the following in this order....

1. Check oil for coolant contamination
2. With engine running check overflow bottle for bubbles
3. Flush radiator and block, replace thermostat
4. Before refilling the system pull the water pump off and check the movement by hand. It should move smoothly when you turn it.
 
You do not need OEM parts, its just preferable due to the quality of the OEM suppliers. I would do the following in this order....

1. Check oil for coolant contamination
2. With engine running check overflow bottle for bubbles
3. Flush radiator and block, replace thermostat
4. Before refilling the system pull the water pump off and check the movement by hand. It should move smoothly when you turn it.
Oil looks good. No bubbles. Is the water pump going to be a pain . I have only replaced on cj5. Thanks
 
Oil looks good. No bubbles. Is the water pump going to be a pain . I have only replaced on cj5. Thanks

The water pump shouldn't be to bad, its right there on the front of the timing cover. You just have to get the belt off then unbolt it.
 
I'd do a good flush and change the thermostat and radiator cap to start. See if that fixes your problem. I was having some overheating issues when under load, and I did the same. I also replaced my modded fan clutch with a new Aisin from Amazon. On the fan clutches, sometimes the temp spring goes bad. I have no problems at all now. If that stuff doesn't fix it, then see about pulling the radiator or water pump.

Do a search for koso slim temp gauge. It's a great mod for our trucks.
 
Water pump on a 3FE is a royal PITA. The entire front of the motor needs to come apart. If it's not leaking and there is no lateral play in the bearing with no noise then chances are it's OK.
As everyone else has mentioned, thermostat and gaskets, radiator cap, and fan clutch. Only use an OEM fan clutch. The 3FE gets a green hub clutch and you don't need to play games with the oil. The stock clutch provides more than enough cooling for the motor and they have about 100K mile lifespan.
Make sure the fan shroud is intact.
Get yourself a thin spray wand that connects to a standard garden hose and clean out the space between the coolant radiator and the AC condenser coil. Crap loves to hide in there. When you pull the fan clutch and shroud you'll get a good look at the corners of the radiator that hide under the shroud. Make sure those fins are clean and clear.
 
Only use an OEM fan clutch. The 3FE gets a green hub clutch and you don't need to play games with the oil.

I wasn't able to get an OEM clutch through Toyota. I was told they were now unavailable from a couple of dealers. Aisin made the OEM clutch, and you can get the green hub clutch from them. The part number is FCT-049. I got it through Amazon for less than $150.

X2 on not messing with the oil. I spent all day in the desert on Saturday, with the AC on and never came close to overheating. Even on the slow climbs, temps never got above 205 or so.
 
Last edited:
Usually if it overheats at speed-under load-and the motor internals are ok it's a radiator core plugged/blocked by something on the front of truck/external radiator-fins blocked by leaves-mud-grass-etc. *OR* have seen super *cheapo* radiators with 50% less tubes vertically that wouldn't cool under any load. In other words a cooling capacity- heat exchangeproblem. You can pull that fan and drive it 70 mph if plenty of air is getting through it.
 
Usually if it overheats at speed-under load-and the motor internals are ok it's a radiator core plugged/blocked by something on the front of truck/external radiator-fins blocked by leaves-mud-grass-etc. *OR* have seen super *cheapo* radiators with 50% less tubes vertically that wouldn't cool under any load. In other words a cooling capacity- heat exchangeproblem. You can pull that fan and drive it 70 mph if plenty of air is getting through it.
That is absolutely incorrect. Due to the (lack of) aerodynamics of the vehicle, a substantial amount of air is forced around the front of the vehicle. Without the negative pressure that the engine driven fan produces, more air will go around the front than through the radiator. You will find that a new or well set up fan clutch/fan will draw tremendous amounts of air through the radiator, assuming the fins are clear on both the condenser and radiator.

Some years ago I had a similar issue. Around 65 mph with relatively warm (not hot) ambient temps, she was unable to hold temperature. Replaced the 100K+ mile clutch with new OEM and never looked back.

OEM fan clutches are available from the Toyota parts dealers here on mud with substantial savings over your local dealerships.
 
That is absolutely incorrect. Due to the (lack of) aerodynamics of the vehicle, a substantial amount of air is forced around the front of the vehicle. Without the negative pressure that the engine driven fan produces, more air will go around the front than through the radiator. You will find that a new or well set up fan clutch/fan will draw tremendous amounts of air through the radiator, assuming the fins are clear on both the condenser and radiator.

Some years ago I had a similar issue. Around 65 mph with relatively warm (not hot) ambient temps, she was unable to hold temperature. Replaced the 100K+ mile clutch with new OEM and never looked back.

OEM fan clutches are available from the Toyota parts dealers here on mud with substantial savings over your local dealerships.

What was incorrect about the preceding post? I don't see anything incorrect about what Howard705 said. I don't read Howard as saying you *should* remove your fan.

Edit: I do agree with your post as well, however don't see an issue with Howard's.
 
I guess all it was the cap. Took it out climbing long steep hill with outside temp In the mid 80s with ac on full blast and temp gauge didn't budge. I guess some times its the simple things. . Thanks every one
 
I was wrong cap didn't work. So I replaced fan clutch. Definitely it. It was 98 yesterday went rafting and pulling long hill in the heat gauge didn't budge could hear the fan roar. Couldn't before. Thank you every
IMG_20140701_131034_200.webp
body
 
Back
Top Bottom