89-94 Pickup Console Cup Holder (1 Viewer)

[bhicks]

We have been making cup holders for the 2nd Gen 4Runners for close to 10 years and have recently been asked if we will make similar ones for the same years pickup. The storage console on the SR5 pickup does not match the 4Runner since the 4Runner has a very shallow compartment due to the rear heater underneath. The pickup storage section is also a little longer and a bit more narrow so our 4Runner cup holder simply did not work correctly. Here are some pics of the new cup holder below. Our 4Runner double cup holder that mounts to the side of the shifter bezel area WILL work on the SR5 pickup. Here are a couple links to the product. We will get them up on ebay later today.

https://www.bh3dprinting.com/product/89-94-toyota-pickup-console-cup-holder/

89-94 Toyota Pickup Console Cup Holder - Etsy

This Car Accessories item is sold by BH3DPrinting. Ships from Whitley City, KY. Listed on Jun 20, 2023

www.etsy.com

 

[bhicks]

This is the double cup holder that mounts to the shifter bezel (if you have one) that works on the pickup. We don't have anything for the base pickup that just has the rubber boots that mount directly to the floor with no bezel.

https://www.bh3dprinting.com/product/2nd-gen-4runner-double-cup-holder/

2nd Gen 4runner Double Cup Holder - Etsy

This Vessels item by BH3DPrinting has 137 favorites from Etsy shoppers. Ships from Whitley City, KY. Listed on Jun 11, 2023

www.etsy.com