78' vs 75' axle question

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

When I was installing an ARB in my78 S/F, I swapped in a third member from a 76 axel so I could move the truck around. (I was missing a part for the ARB and had to order it so things took a while.) However, I did not hook up the driveshaft so I guess there might be a chance that the pinion flange bolt pattern is different but I’m pretty sure everything is interchangeable.
 
brakes too

Are the brake drums and everything identical? Are 75's the manual adjusters, or are both. I mean aren't the 78' rear axles automatic adjust brakes or the screwdriver method? Or am I all wrong and the 75's are auto adjust too?

Thanks
:mad: :mad: :mad: Donkey
 
donkey said:
Or am I all wrong ?


Yep.


Welcome.


Land Cruiser 40 series rear brakes were ALL manual adjusted.


Even the 08/80 single wheel cylinder set up. The parking brake must be acctuated in order to keep the shoes adjusted, or, you crawl under there with an adjusting tool, and adjust them on these later model axles. There are not any ' automatic' or 'self-adjusting' drum brakes on Land Cruiser.


Good luck!


-Steve
 
all right

Thanks so much for the info Steve.

The rear axle I am working with has two places for shock mounts, one on the perch itself and one on the bottom of the u-joint bracket dealy. Is one of these places going to be better than another for a SUA with a 5 inch Alcans Lift? Differences look to be shock angles and lengths. What is better?

Thanks
:mad: :mad: :mad: Donkey
 
donkey said:
one on the bottom of the u-joint bracket dealy.




HUH????


If you intend on using this truck off road, I would use the one that is less likely to incure damage from goodies on the trail.....rocks, logs, hidden fun things in mud, etc.


Good luck!


-Steve
 
Back
Top Bottom