'75 distributor advance/retard

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Apr 16, 2005
Threads
13
Messages
1,023


so i've been poking around on search, and it seems that my '75 would have the small dist and vac retard, but mine has a large cap (last time I ordered cap and wires I had to return it and get the big one) so I think I have a bastard PO resto issue. anyway, my dist. vacuum diapragm doesn't do anything when vac is applied. so how do I figure out what I have (retard/advance?), in order to find out what I need. this is on a '75 fj40, canadian. I think april DOM
any help appreciated, thanks :beer:
 
There is a crimp in the middle of the vacuum diaphragm. If the vacuum fitting (from the carb) is between the crimp and the distributor, it's vacuum retard. If the crimp is between the vacuum fitting and the distributor, it's vacuum advance. There are several combinations of advance/retard through the various model years.

If your advance mechanism does nothing with vac applied, the diaphragm may be dead. It should either push your contact plate CW or pull it CCW.

Good Luck.
 
Has to be replaced. I don't believe they are available new anymore. You'll have to buy a used one. Are you sure you gave it a good test? Does the contact plate in your distributor turn easily by hand?
 
dirty rotten PO,

It wasn't working, took it out and then it did, ends up they had used a bolt that was too long, and so it went right through and bound the shaft so that nothing could move. the bit on the distributor that it turns was a bit stiff, but after a bit of wd-40 and working it back and forth a few times, it's fine.

thanks for the advice
 
I don't think your PO swapped on you. 75 should have the larger cap. I don't know where you would have read otherwise.
 
Back
Top Bottom