74 carb linkage missing?

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Dec 5, 2004
Threads
6
Messages
40
Location
Yakima, WA
During reassembly of my 74 Aisin carb I was using the Haynes manual to set the linkage. It asked me to set a gap between the stop lever and the damper arm. I seem to be missing the high speed valve stop lever. I looked back at all my pictures before disassembly and it was always missing. It ran pretty well before but never great.
I'm not sure how to proceed. Just leave it off? Parts carb?

B5EBFF6C-585C-401E-93D2-E830BC3AF58F.webp


BC5FC3C6-BFE6-43D0-B1DA-B65410CFBCE4.webp


A0F11F71-1AB9-40BB-97AE-83C4257EECFC.webp


image.webp
 
Correct, just the counter weight closes it. FJ40Jim and 65swb45 have commented about the high speed valve in a few threads. I think if it opens prematurely the secondary side will run a little lean.
 
Back
Top Bottom