72 Trans hump

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Jan 17, 2006
Threads
34
Messages
450
I'm in need of some helpful advise. I have a 72 fj40....originally a 3 spd floor. Now has a 4 spd.... I do not like to gaping hole in the trans hump... besides replacing with a fiberglass hump does a later model cover i.e 75-78 fit w/o modification? or am I doomed to follow the more diff. path! Please fill my brain til its full!!

Thanks Brian
 
weld in a patch
 
Hi All:

I have a 11/73 FJ40. It was a parts car until a previous owner brought it back to life. I have no idea what tranny it originally came with, but I suspect it was the floor mounted three-speed.

When I got it there was a four-speed fitted. The tranny humb can obviously been modified. But, the aftermarket shift boots are large enough to cover the hack job on the tranny hump.

HTH!

Regards,

Alan
 
Did tranny humps change between 71 and 72?

My 71 was changed from a 3-speed tranny/transfer to a 4-speed tranny/transfer.

The hump has not been altered, at least not that I can see. Everything fits like a glove.
 
You can do what I did and use FJ60 boots and you'd be surprised what it will cover.
Ed
 
Later hump will NOT fit without a fair amount of mods. It's LONGER for starters.

Unless you're absolutely certain you will never change trannies or need to do a clutch job again, or this is a show-car build, I would cover the hole with a piece of equal guage sheetmetal and screws that can be removed when you need to do the next 'service' on the truck. It sure makes it easier than pulling the seat and tank etc to get the tranny hump out.

My .02

Mark A.
 
Thanks for the reply's. I am looking to replace or repair the hack tranny hump. The cover is in great shape except for the huge hole the po decided to practice his/her skills on. The cruiser is in great shape after a few years of restore here and there. I'm getting mixed answers from places I have called about covers fitting and not fitting. If a three speed floor cover will work on a four speed floor why is my cover have a gaping hole in it? Does a four speed trans shifter line up with a three speed shifter?
 
I dont know which hole you guys are talking about. I cut a small notch in my 72 tranny hump to fit the 4 speed and that was it.
 
IM001184.webp



This is the cover off the cruiser
IM001184.webp
 
Ahh. I see you are a user of the safety sandals. Nice to meet another member.
 
About the closest I get to shoes at home!
 
Do as Mark said and just cut a piece of sheet metal to cover the hole and leave it open, of course for the 4 speed. On my 73, I run an sm420 with a shift boot from a sm465, works good.
 
Thanks bill and everyone else. Sounds like I'll be going that route. A good time to learn to weld!

Brian
 
Back
Top Bottom