5" lift problem newbee

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
May 19, 2009
Threads
2
Messages
3
hey guys/girl im new to this site, but very glab i found it, ive just picked up an 80 series, its a 1993 model, now im wanting to put a 5" sprin lift in it, and down here in australia there is a few different ones to choose from, all claming to be an of the shelf bolt straight in kit.
now the problem i have is that one of my mates has warned me tht with a kit like that the front drive shaft will be on a bad angle and will vibrate?? is this goin to happen? non of the 4x4 shops have said a word about it? cheers dazza.
 
It might vibrate - you can always go with a DC shaft if it does. Stick closer to 3.5-4" of lift and you can run a DC shaft with near perfect caster, easy enough to do. Plus, 5" of lift makes 35" tires look tiny, so unless you are going 37's you'll probably like the lower lift better anyway.

I have 37's on a 3.5" lift, and visually it is perfect.
 
look to see how these kits deal with caster correction, if at all. That will determine the likely hood of vibrations and what type of drive shaft should be used.

Truth. I'm running OME "J" springs with a 2" spacer in the front. No castor correction and no driveline vibs. I'm sure that will change as soon as I get sick of trying to herd the truck to keep it in it's lane and fix the castor!:cheers:
 
Back
Top Bottom