Hey there. Swapping a Cummins 4BT (and 21-spline H55F) into our 1987 FJ60 from the 2F and H42.
This is going to be my wife's forever vehicle and it is going to live in Costa Rica (so lots of steep grades and off-roading at times). The main purpose is point A-to-B, its not being built as a crawler.
With all of this in mind I am looking at purchasing a "new" engine from Big Bear and it looks like their 130HP (CPL: 2093 with HX30 turbo) is what we want. But it has a water jacketed aftercooler that dresses over the valve covers and my question is really about if anyone has put this in or knows of the clearance or at least ideas of how to measure. And any other advice (other than "see x post where they did this already" unless it really is relevant).
This is what I believe the 130HP configuration looks like.
Thank you
This is going to be my wife's forever vehicle and it is going to live in Costa Rica (so lots of steep grades and off-roading at times). The main purpose is point A-to-B, its not being built as a crawler.
With all of this in mind I am looking at purchasing a "new" engine from Big Bear and it looks like their 130HP (CPL: 2093 with HX30 turbo) is what we want. But it has a water jacketed aftercooler that dresses over the valve covers and my question is really about if anyone has put this in or knows of the clearance or at least ideas of how to measure. And any other advice (other than "see x post where they did this already" unless it really is relevant).
This is what I believe the 130HP configuration looks like.
Thank you