Can anyone take as many pictures as possible of the access panels that are in front of the wheel arches on the later model long beds. Hopefully with measurement of where the holes are and perhaps the amount the panel overlaps the piece of bed it sits on and screws into? I've attached a picture of the piece of the bed floor that the access panel sits on that Awl-tec made and a screen grab from one of his video of the panel itself.
Some background on why I'm asking. I purchased Awl-tec's flat plans and I'm having a company make a new bed floor out of 14GA. When we changed metal thickness from 16GA to 14GA it altered the overlap/hole alignments so the company needs some measurements to finish the project.
Thanks in advance everyone and I look forward to sharing with everyone a complete 45 floor in 14GA when this is all said and done!!
Some background on why I'm asking. I purchased Awl-tec's flat plans and I'm having a company make a new bed floor out of 14GA. When we changed metal thickness from 16GA to 14GA it altered the overlap/hole alignments so the company needs some measurements to finish the project.
Thanks in advance everyone and I look forward to sharing with everyone a complete 45 floor in 14GA when this is all said and done!!
