40 Grinding when not under power

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Mar 10, 2004
Threads
50
Messages
273
My 1962 JF40 is grinding. I think it is somewhere in the driveline. On accelleration, all is well, on decelleration things are pretty good. The area where this is noticed most is just when letting off the gas or with the tranny not in gear and just coasting. Basically when there is no power on the driveline.

Is this the vibration they are refering to in the Tighten your Driveline post?
https://forum.ih8mud.com/showthread.php?t=24510

Thanks for any ideas,

Eric
 
I just had a similar experience with my 40. It turned out to be a bearing in the t/c.

You'll have to put your 40 up on blocks (chock the other tires) and turn the driveshafts by hand and "feel" (and listen) where the grinding is.
 
One way to narrow your search is to remove the rear driveshaft and take a drive with the front axle providing the power. See if the noise goes away.
Rob M
could bbe u joints, rear diff. or something else....
Rob M
 
Right now it is in the garage as I am installing a stop signal switch. I do not remember if the noise is there when the clutch is in. It definitely is there when the clutch is out.
It sounds like while it is in the garage, I better at least checkt the bolts and maybe even lift it to listen for noise.
 
Back
Top Bottom