3FE Runs Hot

This site may earn a commission from merchant affiliate
links, including eBay, Amazon, Skimlinks, and others.

Joined
Feb 24, 2013
Threads
5
Messages
76
Location
Coronado,CA
Hi all,
I recently rebuilt my 3FE. Motor runs great around town. I did my first ever road trip to Sedona last weekend and the motor ran hot going up the grade(6%). I had to pull over a few times in fear of overheating. I vented the radiator cap to relieve pressure and the temp returned to normal. Continued up the grade doing about 40MPH and this helped. The problem only presented itself when driving up the grades. I drove the flat areas with the AC and no issues.
Is this normal for the 3FE?
 
What do you mean by, "I vented the radiator cap to relieve pressure".
The cooling system is supposed to be pressurized when hot. That's how it works. If you "vented" the cap when hot, then coolant should have sprayed out and scalded you. If no coolant came out then your cooling system is not full.
Engines shouldn't overheat when put under load unless the cooling system is compromised.
 
image.webp
What do you mean by, "I vented the radiator cap to relieve pressure".
The cooling system is supposed to be pressurized when hot. That's how it works. If you "vented" the cap when hot, then coolant should have sprayed out and scalded you. If no coolant came out then your cooling system is not full.
Engines shouldn't overheat when put under load unless the cooling system is compromised.

This is the rad cap I use. Engine should not overheat. Trying to figure it out. Replaced radiator, thermostat, water pump, fan clutch, hoses in engine rebuild.
Confused
 
Do you have any aftermarket (more accurate) temp gauges? Looking to see exactly how hot it did get.

Where is your timing set?

Do you have any large lights or bumpers blocking airflow?

(For reference, my 3fe will run up to about 206 pulling the Sunset grade on I-17 with 33's, the heat on and blowing, 2nd gear, and 50-55mph. This is regardless of what time of year of is. My timing is bumped up a little, and all of the same cooling refreshments that you mentioned.)
 
Have you tried an OEM radiator cap? I don't recall what the relief pressure of the OEM cap is, but I believe it is higher than 13 PSI.
When you "vented" the cap, did air come out or did coolant come out?
Did you use an OEM green hub fan clutch or aftermarket?
Did you use an OEM thermostat and did you replace the the o-ring that sits on top of the stat?
Is your fan shroud intact and making good contact to the radiator all the way around?
 
Last edited:
Back
Top Bottom